4
Programming Erase Guide
All devices that are programmed properly in the Powr-Touch
®
II are held in the system's memory. If a device number has been
programmed/assigned to four relay sets, it cannot be programmed to additional relay sets. If a mistake was made during the
programming sequence and a device number was accidentaly assigned to the wrong relay set, an erase procedure will be required.
Refer to the erase options examples below.
Complete system erase:
Note:
This procedure will erase
all
device assignments in the Powr-Touch
®
II system.
1.
Set the No. 12550-100 TouchPad dip switch to address "0" (Program mode)
2.
Enter
999
3.
Enter
Backstop 00
4.
Press the
DOWN / Off
button.
Individual device assignment erase:
Note:
This procedure will erase the device number assignment selected in the Powr-Touch
®
II system.
1.
Set the No. 12550-100 TouchPad dip switch to address "0" (Program mode)
2.
Enter
900
3.
Enter the device type and number. Example:
Backstop 03
4.
Press the
DOWN / Off
button.
In the above example, Backstop 3 will be erased from all memory locations (single and multiple operation) in the Powr-Touch
®
II
system.
Relay panel erase:
Note:
This procedure will erase all device number assignments in the selected Powr-Touch
®
II relay panel.
1.
Set the No. 12550-100 TouchPad dip switch to address "0" (Program mode)
2.
Calculate the code number to enter. To erase relay panel address "0", add the number "1" to the relay panel address number, then
add the constant number "900". Example: Relay panel address
"0" +1 + 900 = 901
.
3.
Enter
901
4.
Enter
Backstop 00
5.
Press the
DOWN / Off
button.
In the above example, all device number assignments in relay panel address "0" will be erased.
Porter Athletic Equipment Company
2500 South 25
th
Avenue, Broadview, IL U.S.A., 60155
Toll Free: (800) 947-6783
•
Phone: (708) 338-2000
•
Fax: (708) 338-2060
www.porter-ath.com
