Porter-Cable PXMS12ISB, Инструкция по эксплуатации

Страница: 12 / 31

Made
of shock-resistant, see-through plastic that provides
protection from each side of the blade. It retracts over
the upper blade guard as the saw is lowered into
the workpiece.
WOODWORKING TERMS
The shaft on which a blade is mounted.
Allows the user to stop the blade from
rotating while tightening or loosening the blade screw
during blade replacement or removal.
A cutting operation made with the blade
at any angle other than 90° to the miter table.
A cut that removes a wedge from a
block of wood so that the end (or part of the end) is angled
at other than 90°.
A cut made using both a
miter angle and a bevel angle at the same time.
A cutting operation made across the grain
of the workpiece.
Performing a cut without using a fence
(guide), hold down or other proper device to prevent the
workpiece from twisting during the cutting operation. Do
not perform any operation freehand. Use a clamp or vise
wherever possible.
A sticky sap from wood products.
Misalignment of the blade.
KERF The material removed by the blade in a through
cut, or the slot produced by the blade in a non-through
or partial cut.
A hazard that can occur when the blade
binds or stalls, throwing the workpiece back toward the
operator.
An angle cut made across the width of the
workpiece.
The area between the marked lines
on the left and right side of the miter-table base. This zone
is identified by No-Hands Zone symbols inside the lines
marked on the miter table base.
Any cutting operation where the
blade does not extend completely through the thickness
of the workpiece.
GLOSSARY OF TERMS
COMPOUND MITER SAW TERMS
Supports the table, holds accessories and allows
for workbench or leg set mounting.
Locks the miter saw at a desired
bevel angle.
To measure the bevel angle of the saw
blade -3° to 48° left.
Helps to keep the workpiece from moving
when sawing.
Helps protect your hands from
the blade in the raised position, it retracts as the blade is
lowered.
MITER LOCK HANDLE Used to rotate the table, and to
rotate the saw to a right or left cutting position.
Measures the miter anlge 0° to 48° left
and right.
To mount the miter saw to a stable
surface.
To start the tool, squeeze
the trigger. Release the trigger to turn off the miter saw.
Locks the miter saw at
a preset positive stop for the desired miter angle.
Locks the miter saw in the lowered
position for compact storage and transportation.
May be on left or right fence or base
to securely clamp the workpiece.
The switch handle contains the trigger
switch. The blade is lowered into the workpiece by pushing
down on the handle. The saw will return to its upright
position when the hanlde is released.
For carrying and transporting the
miter saw.
An electric brake has been provided
to quickly stop blade rotation after the switch is released.
Read and understand for your own
safety. Make sure all labels are present on machine and
legible.
Convenient storage to prevent
misplacing the blade wrench.
12