5- ENG
D22720
ASSEMBLY
SPECIFICATIONS
OPERATION
Accessories Required
IMPORTANT:
Line pressure or hose inside diameter should be increased to compensate
for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8” I.D.
and fittings should have 1/4” NPT thread.
Free Speed @ 90 PSI
160 RPM
(Forward/Reverse)
Maximum Working Pressure
90 PSI
Air Inlet
1/4" NPT
Recommended Hose Size
3/8" I.D.
Maximum Torque
60 Ft./Lbs.
Air Consumption @ 90 PSI
4.9 SCFM
Before each use:
●
Drain water from air compressor tank
and condensation from air lines. See
air compressor’s operators manual.
Disconnect the
ratchet wrench from
the air supply before lubricating or
changing sockets.
●
Lubricate tool, see “Maintenance”
section in this manual.
Impact wrench
sockets and
accessories must be used with this
tool. Do not use hand sockets and
accessories.
●
Select the required impact socket. This tool has a 3/8" square drive, use 3/8” deep
sockets. Use 3/8” extensions only when needed.
Connect tool to air hose of recommended size.
NOTE:
The use of a quick connect
set makes connecting easier.
IMPORTANT: The use of air filters and air line lubricators is
recommended.
To use:
●
Turn air compressor on and allow air tank to fill.
●
Set the air compressor’s regulator to 90 PSI. This tool operates at a maximum
90
PSI
pressure.
●
Place tool in forward or reverse position.
●
Depress the throttle control lever to operate tool.
NOTE:
The throttle control lever
provides instant response when depressed.
●
Release throttle control lever to stop tool.
●
Always disconnect air supply when changing sockets.
●
When job is complete, turn the air compressor off and store as described in the air
compressor operator manual.
Air Inlet
Throttle Control Lever
