●
Place tool in forward or reverse position. Push button in
on “F” side for forward or “R” side for reverse.
●
Depress the trigger to operate tool.
●
Release trigger to stop tool.
●
Always disconnect air supply when changing sockets.
●
When job is complete, turn the air compressor off and
store as described in the air compressor operator
manual.
6- ENG
D22727
Push button all the way in on
the “F” side for Forward
position.
Push button all the way in on
the “R” side for Reverse
position.
MAINTENANCE
Lubrication
Air tools require lubrication throughout the life of the tool. The air motor and bearing uses com-
pressed air to power the tool. Because moisture in compressed air will rust the air motor, you must
lubricate the motor daily. An inline oiler is recommended.
To lubricate the air motor manually:
1.
Disconnect the tool from the air supply holding it so the air inlet faces up.
2.
Depress the trigger and place one to two drops of air tool oil in the air inlet
Depressing the trigger helps circulate oil in the motor.
NOTE:
Use SAE #10
weight oil if air tool oil is not available.
3.
Connect the tool to an air source, cover the exhaust end with a towel and run
for a few seconds.
Any excess oil in the motor is immediately expelled
from the exhaust port. Always direct exhaust port away
from people or objects.
Failure to lubricate the tool at the air inlet will void your
warranty.
