8
Fig. P
4. Insert the located tubes () into the two extension
tube brackets under the table (7). (fig. Q)
5. Snap two plastic stops (3) over the end of the
tubes (). Make sure the locating pin in the location
seats fit into the matching holes in the tubes. (Fig. Q)
NOTE:
The slanted top of the rear outfeed support ()
MUST be facing the back of the saw as shown in
fig. Q.
Fig. Q
INSTALLINg THE BLAdE (fIg. r, S, T)
To avoid injury from an accidental start, make sure
the switch is in the OFF position and the plug is not
connected to the power source outlet.
NOTE:
The saw blade is packed in the blade storage
located on the right side of base.
1. Remove the table insert (1) by inserting your finger
into the opening () and pulling up. Raise the blade
to the maximum height position by turning the blade
elevation handwheel clockwise. (fig. R)
Fig. R
3
7
3
WArNINg
!
Dimple End
3
5
6
4
Fig. N
INSTALLINg THE BLAdE TILTINg HANdWHEEL
(fIg. O)
NOTE:
0° - 45° is printed on this handwheel.
.
Bag "A"
_
Attach the blade tilting handwheel () to
the blade tilting rod on the right side of the saw in
the same manner as you attached the elevation
handwheel.
. Attach and tighten the crown nut () using a 3 mm
wrench.
Fig. O
INSTALLINg THE rEAr OuTfEEd SuppOrT
(fIg. p, Q)
.
Bag "B, C, D"
_
Insert one tube () into the rear
outfeed support (). (fig. P)
NOTE:
They must be inserted into the back
of the extension with the dimple end last so that
the bar will hold the extension in place.
. Take one of the black plastic stops (3) and place it
over the small hole (4) on the tube as shown in fig. P.
The pin inside the stop should snap into place when
pressed over the hole in the tube (). (fig. P)
3. Insert the other tube the same way onto the support
and lock into place with one black plastic stop.
4. Attach the rubber pad (5) to the inside of the rear
table extension (). Thread the screw (6) through the
rubber pad (5) with a screwdriver. Do not overtighten
the screw (6). (fig. P)
3
4
5
Содержание PCB222TS
Страница 11: ...11 A B C D E F G H I J K L M N O P Q UNPACKING YOUR JOBSITE TABLE SAW R S T U V ...
Страница 38: ...43 NOTEs ...