5
Symbols
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V..................volts
A ..................amperes
Hz................hertz
W..................watts
min ..............minutes
................alternating current
............direct current
no ................no load speed
................Class I Construction
..................earthing terminal
(grounded)
................safety alert symbol
................Class II Construction
.../min or rpm...revolutions or
(double insulated)
reciprocation per minute
sfpm ............surface feet per minute
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CHARGERS
SAVE THESE INSTRUCTIONS:
This manual contains important safety instructions for
battery chargers.
• Before using charger, read all instructions and cautionary markings on charger, battery
pack, and product using battery pack.
Shock hazard.
Do not allow any liquid to get inside charger.
Burn hazard.
To reduce the risk of injury, charge only designated
PORTER-CABLE
batteries. Other types of batteries may burst causing personal injury
and damage.
Under certain conditions, with the charger plugged in to the power
:
:
:
LI-ION Battery Packs and Chargers
Battery: LI-ION 18V
Charger: LI-ION
PC18BL
PC18BLX
PC18BLEX
PCLMVC
PCXMVC
Description Cat. #
NI-CD Battery Packs and Chargers
This product can accept any of the batteries and chargers listed in the chart below.
Battery: NI-CD 18V
Charger: NI-CD
PC18B
PCMVC
PCXMVC
Description Cat. #
FUNCTIONAL DESCRIPTION
1. On/Off Switch
2. Sanding Base
3. Vacuum Port
4. Battery Compartment
5. Finger Attachment
6. Vacuum Port Adaptor
1
2
3
4
A
6
5
90550099 PC1800DS Crdl Sander REVISED 4/1/09 1:52 PM Page 5
