3
b) Do not use the power tool if the switch does not turn it on and off.
Any power
tool that cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery pack from the
power tool before making any adjustments, changing accessories, or storing
power tools.
Such preventive safety measures reduce the risk of starting the power
tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons
unfamiliar with the power tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts,
breakage of parts and any other condition that may affect the power tool’s
operation. If damaged, have the power tool repaired before use.
Many
accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc., in accordance with these
instructions, taking into account the working conditions and the work to be
performed.
Use of the power tool for operations different from those intended could
result in a hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts.
This will ensure that the safety of the power tool is maintained.
ADDITIONAL SPECIFIC SAFETY RULES
SAFETY INSTRUCTIONS FOR ALL SAWS
a.
Keep hands away from cutting area and the blade. Keep your second hand on
auxiliary handle, or motor housing.
If both hands are holding the saw, they
cannot be cut by the blade.
b.
Do not reach underneath the workpiece.
The guard cannot protect you from the
blade below the workpiece.
c.
Adjust the cutting depth to the thickness of the workpiece.
Less than a full
tooth of the blade teeth should be visible below the workpiece.
d.
Never hold piece being cut in your hands or across your leg. Secure the
workpiece to a stable platform.
It is important to support the work properly to
minimize body exposure, blade binding, or loss of control.
e.
Hold power tool by insulated gripping surfaces when performing an operation
where the cutting tool may contact hidden wiring or its own cord.
Contact with
a "live" wire will also make exposed metal parts of the power tool "live" and shock
the operator.
f.
When ripping always use a rip fence or straight edge guide.
This improves the
accuracy of cut and reduces the chance of blade binding.
g.
Always use blades with correct size and shape (diamond versus round) of
arbor holes.
Blades that do not match the mounting hardware of the saw will run
eccentrically, causing loss of control.
h.
Never use damaged or incorrect blade washers or bolt.
The blade washers and
bolt were specially designed for your saw, for optimum performance and safety of
operation.
CAUSES AND OPERATOR PREVENTION OF KICKBACK:
• Kickback is a sudden reaction to a pinched, bound or misaligned saw blade, causing
an uncontrolled saw to lift up and out of the workpiece toward the operator.
• When the blade is pinched or bound tightly by the kerf closing down, the blade stalls
and the motor reaction drives the unit rapidly back toward the operator.
• If the blade becomes twisted or misaligned in the cut, the teeth at the back edge of the
blade can dig into the top surface of the wood causing the blade to climb out of the kerf
and jump back toward the operator.
Kickback is the result of saw misuse and/or incorrect operating procedures or
conditions and can be avoided by taking proper precautions as given below:
:
90559271 PC15TCS PC15TCSM CIR SAW.qxd:??????-00 Cir Saw book 12/21/09 8:27 AM Page 3
