7
18. Do not short across the terminals of the battery pack: EXTREMELY
HIGH TEMPERATURES COULD CAUSE PERSONAL INJURY OR FIRE.
19. Double insulated tools are equipped with a polarized plug (one blade
is wider than the other). This plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to install a polarized outlet. Do
not change the plug in any way.
Double Insulation
eliminates the need for the three wire grounded power cord and ground-
ed power supply system.
20. Dispose of expended batteries properly. The
Delta Battery Packs contains rechargeable, nickel-cad-
mium batteries. These batteries must be recycled or
disposed of properly. Drop off expended battery packs
at your local replacement battery retailer, your local
recycling center, or at a Delta Service Center (see list on
back page of this manual). Applicable fees for the col-
lection and recycling of these batteries (in the United
States), have been paid to the RBRC
™
. For further infor-
mation, call: 1-800-8-BATTERY.
REPLACEMENT PARTS
When servicing use only identical replacement parts.
RBRC™ is a Trademark of
the Rechargeable Battery
Recycling Corporation.
FUNCTIONAL DESCRIPTION
FOREWORD
Delta Model CL180PS is a cordless finishing sander. This sander is designed
for its portability and all-purpose sanding.
CHARGING THE BATTERY
CHARGING THE BATTERY PACK GENERAL
Before using your cordless tool for the first time, the battery pack should be
fully charged. If the battery pack is installed in the tool, remove it by following
instructions under INSTALLING OR REMOVING BATTERY PACK.
As a battery pack approaches the discharged state, you will notice a sharp
drop in tool performance. When the tool is unable to perform the task at hand,
it is time to recharge the battery pack. Recharging the battery pack before this
condition is reached will reduce the total work life of the pack. Discharging the
pack beyond this point can damage the pack.
NOTE: Battery temperature will increase during and shortly after use.
Batteries may not accept a full charge if they are charged immediately
after use. Allow the battery pack to cool to room temperature before
charging for best results.
The battery charger must rest on the four pads provided on the bot-
tom of the case. Vent slots in top and bottom of charger must not be obstructed.
Do not charge battery when temperature is BELOW 40°F (4.4°C) or ABOVE 104°F
(40°C).
NOTICE: THE MANUAL COVER PHOTO ILLUSTRATES THE CUR-
RENT PRODUCTION MODEL. ALL OTHER ILLUSTRATIONS ARE
REPRESENTATIVE ONLY AND MAY NOT DEPICT THE ACTUAL
COLOR, LABELING OR ACCESSORIES AND MAY BE INTENDED TO
ILLUSTRATE TECHNIQUE ONLY.
Содержание CL180PS
Страница 13: ...13 NOTES...