Porter-Cable A09608-0412-0, Инструкция по эксплуатации

Страница: 14 / 20

14- ENG
A09608
MAINTENANCE
When performing
maintenance, you
may be exposed to hot surfaces,
water pressure, or moving parts
that can cause serious injury or
death!
Before performing any maintenance
or repair, disconnect spark plug
wire, let engine cool and release
all water pressure. The engine
contains flammable fuel. DO NOT
smoke or work near open flames
while performing maintenance.
To ensure efficient operation and
longer life of your pressure washer,
a routine maintenance schedule
should be prepared and followed.
If the pressure washer is used in
unusual conditions, such as high-
temperatures or dusty conditions,
more frequent maintenance checks
will be required.
ENGINE
Consult the Engine Owners
Manual for the manufacturer's
recommendations for any and all
maintenance. NOTE: The frame is
equipped with an oil drain hole to help
make changing the engine oil easier.
To Check Oil:
1.
Remove
dipstick/oil
plug from
pump and
wipe clean.
2.
Insert
dipstick/oil
plug fully
into pump,
then
remove it.
3. Oil level is correct when oil covers
the lower 1/2 inch of end of
dipstick/oil plug.
How To Change Pump Oil
1.
Loosen dipstick/oil plug.
2.
Place a container under the oil
drain plug.
3. Remove oil drain plug.
4. After oil is drained replace oil
drain plug. Tighten securely.
5.
Remove dipstick/oil plug and fill
with 13.5 oz (399 ml) of 30W non
detergent oil.
6. Replace dipstick/oil plug and
tighten securely.
PUMP
NOTE: The pump was filled with oil at
the factory.
1. Change pump oil after the first ten
(10) hours of operation and every
fifty (50) hours thereafter.
Dipstick/oil plug
Oil Drain Plug