background image

7

Gauge) for safety.

The smaller the gauge number of the wire, the greater the capacity

of the cable, that is 16 gauge has more capacity than 18 gauge. When using more than
one extension to make up the total length, be sure each individual extension contains
at least the minimum wire size.

• 

Do not place any object on top of charger or place the charger on a soft surface
that might block the ventilation slots and result in excessive internal heat. Place
the charger in a position away from any heat source.

The charger is ventilated

through slots in the top and the bottom of the housing.

• 

Do not mount charger on wall or permanently affix charger to any surface.

The

charger is intended to use on a flat, stable surface (i.e., table top, bench top).

• 

Do not operate charger with damaged cord or plug —

have them replaced

immediately.

• 

Do not operate charger if it has received a sharp blow, been dropped, or
otherwise damaged in any way. 

Take it to an authorized service center.

• 

Do not disassemble charger;

take it to an authorized service center when service or

repair is required. Incorrect reassembly may result in a risk of electric shock,
electrocution or fire.

• 

Disconnect the charger from the outlet before attempting any cleaning. 

This will

reduce the risk of electric shock. Removing the battery pack will not reduce this risk.

• 

NEVER attempt to connect 2 chargers together.

• 

The charger is designed to operate on standard household electrical power (120
Volts). Do not attempt to use it on any other voltage. 

SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTION FOR BATTERY PACKS

For safe operation, read this manual and manuals originally supplied

with tool before using the charger.

The battery pack is not fully charged out of the carton. Before using the battery pack
and charger, read the safety instructions below. Then follow charging procedures
outlined.

READ ALL INSTRUCTIONS

• 

Do not incinerate the battery pack even if it is severely damaged or is completely
worn out.

The battery pack can explode in a fire. Toxic fumes and materials are

created when LI-ION battery packs are burned.

• 

Do not charge or use battery in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust.

Inserting or removing the battery from the charger

may ignite the dust or fumes.

• 

If battery contents come into contact with the skin, immediately wash area with
mild soap and water.

If battery liquid gets into the eye, rinse water over the open eye for

15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte
for Li-ion batteries is composed of a mixture of liquid organic carbonates and lithium
salts. For NI-CD batteries it is a 25-35% solution of potassium hydroxide.

• 

Contents of opened battery cells may cause respiratory irritation.

Provide fresh air.

If symptoms persists, seek medical attention.

Burn hazard.

Battery liquid may be flammable if exposed to spark or flame. 

• 

Charge the battery packs only in 

PORTER-CABLE 

chargers.

• 

DO NOT splash or immerse in water or other liquids. 

This may cause premature cell

failure.

• 

Do not store or use the tool and battery pack in locations where the temperature
may reach or exceed 105°F (40C˚) (such as outside sheds or metal buildings in
summer).

Never attempt to open the battery pack for any reason. If battery pack

case is cracked or damaged, do not insert into charger. Do not crush, drop or damage
battery pack. Do not use a battery pack or charger that has received a sharp blow, been
dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer,
stepped on). Damaged battery packs should be returned to service center for recycling.

:

:

:

90562807 PC1800SS rotary saw.qxd:??????-00 Cir Saw book  3/24/10  8:27 AM  Page 7

Содержание 18 Volt Cordless Rotary Saw
















Отзывы: