Portek MAXI Mk2, Инструкция по эксплуатации

Страница: 3 / 8

Before First Use
Unpack the MAXI Mk2 and check all parts for any damage. Dispose of the packaging
materials and read the instruction manual carefully. The MAXI Mk2 is supplied partly
assembled, please assemble the machine as follows:
1. Remove the adjustment screw from the
accessory bag. Unscrew nut from the end of the
adjustment screw and feed through the motor
housing as shown right. Place the nut into the
underside of the motor housing and begin to
tighten the screw.
2. Remove the large locking wheel from the chain
guide assembly and place the bolt end through
the hole in the unit base. Replace the locking
wheel on to the bolt and adjust to the required
angle before fully tightening. When installing
the MAXI Mk2 on to a work bench, make sure
that the locking screw is easily accessible.
3. Remove the grey plastic tension nut from the
end of the tension cable. Pull the cable through
the chain guide clamping piece and replace the
plastic tension nut.
Work Surface Mounting
4. Place the unit base on to a solid, level work
surface. Ensure the base extends out far enough
over the edge so that the chain can hang freely
and you have easy access to the vice angle adjustment screw underneath. Mount the
base to the work surface through the two 9mm (1/4") mounting holes (bolts not
included).
5. The MAXI Mk2 is assembled and ready for use! The pre-installed grinding wheel is for
universal use. To replace a grinding wheel see “Grinding Wheel Replacement” section.
Assembly of MAXI Mk2
Adjustment
screw
Base
Motor
housing
Chain guide
assembly tension
cable
Work surface
mounting holes
MAXI_operators booklet.qxd:Layout 1 12/9/13 17:34 Page 3