7
standby mode.
Out of range indication
If your headset has registered and is in located range, the “In use” LED will blanking steadily, when your
headset goes out of range, the communication link will be lose temporarily, the “In use” LED will
blink.
If you go back to the located range again, the communication link will restore, also the “In use” LED will
blanking steadily.
Note: your talk will be cut without any audible warning tone if you are in a talk and out of the located range.
Registration
The headset and base shall be factory pre-registered with the identification digital security codes, which are
stored into the non-volatile memory, so that your headset shall be ready for working after out-of-box. However,
your headset shall also has a procedure to allow you to re-do the registration operation in case of the link is lost
accidentally.
-press
d
key 3 times,
Press and hold
c
key for 3 seconds on the headset “In use” LED is ON, your headset
entered the registration mode
-Press and hold
SUB
key for 3 seconds on the base until “SUB” LED is ON, the base also entered the
registration mode.
Note: SUB key A1-A4 is for channel A station, B1-B4 is for channel B station.
-About 5-10 seconds the headset “In use” LED is OFF that means the headset has located the base, and the base
until “SUB” LED is OFF too.
-If the headset does not locate the base, the headset “In use” LED will be blink after 15 seconds and it will
return to the non-located mode. Try again and check that you are not in the interference environment
Note: your base can register up to
eight
headsets. One headset register on the every subscribe key.
Unsubscribe headset registered
-At standby mode
-Press and hold
SUB
key enter the base’s registration mode with the “SUB” LED is ON
-Press and hold
SUB
key again until the “SUB” LED is OFF
-All headsets registered to this part are cleared
Note: (1)SUB key A1orA2 to unsubscribe both A1 and A2.
(2)SUB key A3orA4 to unsubscribe both A3 and A4.
(3)SUB key B1orB2 to unsubscribe both B1 and B2.
(4)SUB key B3orB4 to unsubscribe both B3 and B4.
Conference talk
When you are in a talk on the base, you can invite another channel headset to join your conversation.
-Press the “All Conference”
key on the base that you want to talk.
-At the all conference mode, both wireless headset and four cord headsets can conference. But when you use
cord phone to a conference, though there are four cord headset interfaces, you can only use two cord headsets,
the other two headsets only for support when necessary
Содержание CS1900
Страница 1: ...1...
