Opening and Locking
27
Door lock under door handle (driver‘s side)
The vehicle cannot be locked
This is recognizable by the fact that the
emergency flasher does
not flash and there is no
locking noise.
The remote control of the key may
– fail due to a fault,
– due to a discharged key battery,
– not function correctly due to radio waves (e.g.
mobile phone) in the vicinity of the vehicle (also
radio contact between remote control and
vehicle in the case of Porsche Entry & Drive).
Emergency locking if the central locking
system has failed
If the vehicle cannot be locked, then:
1.
Remove the emergency key from the vehicle
key.
Please see the chapter “EMERGENCY KEY”
on page 27.
2.
Open the driver’s door.
3.
Lift the door handle on the driver’s door
(
ILLUSTRATION
).
Insert the emergency key in the door lock, turn
90° clockwise and remove the emergency key
again.
Successful locking is indicated by the
emergency flasher
flashing twice.
4.
Release the door handle and shut the door.
The driver's door is now locked.
5.
To lock the
passenger’s door
using the
emergency procedure, insert the emergency
key in the door lock in the driver’s door again,
turn 90° clockwise and remove the emergency
key again.
The passenger’s door is now locked.
6.
Information
The passenger’s door cannot be locked using
the emergency procedure if the central locking
system is defective.
Information
If the central locking system is defective,
operating the lock cylinder in the driver’s door will
lock all functioning locking elements of the central
locking system.
f
Have the fault in the central locking system
remedied at your nearest authorized Porsche
dealer.
Emergency key
Removing emergency key
1.
Push the release button to the side.
2.
Pull out the key.
Insert emergency key
f
Push in the key until the release button
engages audibly.
Information
Different vehicle settings are stored on the
respective key when the vehicle is locked,
provided the vehicle is fitted with the relevant
equipment.
14_C7NF_21.book Seite 27 Mittwoch, 26. März 2014 12:15 12
