Porsche 971044033, Руководство по установке

Страница: 25 / 179

24
Installation Compact charging pole
Installation Compact
charging pole
Installation on existing ground
1.
Mark the drill holes on the ground through the
cable gland.
2. Drill the fastening holes ø 14 mm and use the
foundation fastening kit in accordance with the
product instructions.
Fig. 2: Drilling dimensions
Installing the compact charging pole
The foundation must be provided on site.
Alternative fastening method:
HILTI HVA (HVU M HAS-R M12x110/168)
(see chapter „Appendix: Foundation fastening kit
Hilti“ on page 32) or similar (see static calculation).
Preparing for distance mounting
1. Brace the anchor rods with the foundation
using four washers A13 and four hexagonal
nuts M12.
The maximum tightening torque is 40 Nm.
2. Set the desired height between 30 mm and
150 mm using four hexagonal nuts M12 and
washers A13.
3. Empty conduit: Protrusion minimum 250 mm
above the foundation.
Fig. 3: Distance mounting
rear
front
Information
The compact charging pole is usually installed
directly (without any spacing) on the prepared
reinforced concrete ground with flooring (e. g.
paving, tarmacadam etc.) (see Fig. 7).
If the flooring is to be finished later, it is possible
to use distance mounting in order to install the
charging pole in advance above the planned floor
covering (see Fig. 3).
1
2
3