Porsche 911 GT2 -, Брошюра

Страница: 13 / 55

· 29 · · 28 ·
The 911 GT2 | Drive
turbine has a lower mass, it
responds more quickly to increas-
ing pressure, spinning up easily
to its optimum speed. The key
disadvantage of using a smaller
turbo is that the back-pressure
generated at higher engine speeds
causes a significant reduction
in performance. Resistance is
caused by the smaller cross-
sectional area through which
the exhaust is required to flow.
On a conventional turbocharger,
the exhaust flow drives a turbine
that is connected to a compressor
on the intake side. By compressing
the incoming air, the amount
of oxygen in a given volume is
increased. Since compression
also causes an increase in
temperature, the air must be
cooled in a device known as an
‘intercooler’. With more oxygen
present in each cylinder charge,
more fuel can be burnt, yielding
greater energy. Since higher
exhaust pressures generate
greater loads on the intake side,
the intake pressure must be
carefully controlled in order to
protect the engine. This ‘boost
pressure’ is limited using ‘waste-
gate’ valves that bypass excess
pressure around the turbine.
Another important factor in
the system is the size of the
turbocharger. Since a smaller
Porsche has a long and celebrated
tradition of using turbocharged
power on both road and track.
On the 911 GT2, we’ve enhanced
this technology with Variable Turbine
Geometry (VTG).
Larger turbo units, which create
lower back-pressure at higher rpm,
take considerably longer to spin
up under power due to the large
cross-sectional area and relative
inertia of the heavier turbine.
Generally, this type of turbo will
only be effective in the medium
rpm range. This phenomenon,
known as ‘turbo lag’, means there
is virtually no turbocharging
effect at lower engine speeds.
Turbocharger with Variable Turbine Geometry (VTG)
Breathe easy – when holding your breath.
Variable Turbine Geometry (VTG).