After checking fit and alignment of sink to cut out,
apply a bead of silicone adhesive to rim of sink.
The use other compounds is not reccomended.
A
Mount the drain assembly
(not included) on the sink,
following faucet
manufacturer's instructions.
Be certain to apply a bead
of sealing putty on the
underside of the drain (Part
"A") in order to ensure a
watertight seal between the
sink and drain. Remove
excess putty after installing
drain on sink.
5
6
Install faucet (not included) and countertop (not
included) following manufacturers instructions.
8
7
NOTE:
To avoid damage to
countertop, install sink such that
future removal from underneath
the countertop is possible.
First, make sure the clearance
between the backsplash, faucet,
fixtures and cabinets are
acceptable for the new sink.
For ADA compliance, all models
must be installed with the
overflow in the rear.
Carefully cut out the enclosed template, then position and trace
the template on the countertop as shown on the template. Make
a mark of the faucet hole centerline on the countertop. Drill a
1/2" pilot hole on the inside of the cut line. Use a saber saw or a
keyhole saw to cut out the countertop opening.
7301515-100 Rev. B
Perimeter of Sink
Cutout
3/4" MIN.
Clip
3/4" MIN.
Clip
FOR MARBLE OR SOLID SURFACE COUNTERTOP
FOR WOOD COUNTERTOP
1
2
Mark and pre-drill the wood screw holes as located on the
enclosed template. Waterproof any exposed areas of wood.
To protect countertop, place it on a foam padding and drill
3/8 Dia. X 1/2 deep hole as per location shown on template.
3
4
Drill 1/8 dia. X 3/8 deep
#10 Wood Screw
Center bowl over cutout and tighten screws (see 3 or 4)
to secure bowl to countertop. Remove excess sealant
from inside lip.
NOTE:
The screws
provided should be
used on countertops
with a minimum 1"
thickness. For thinner
countertops, use
appropriate anchors
and fasteners.
#10-24
Machine screw
Brass insert, exopy in place with
threaded evd exposed.
(Exopy not supplied.)
