Room temperature measurement
POPP Smart Thermostat measures the temperature using several built-in sensors to ensure accurate and precise
control.
Room temperature in POPP Smart Thermostat is calculated and measured about 20 cm in front of this thermostat.
Please note that sources of cold or heat, such as open fires, direct sunlight, or draughts, may affect the
temperature measurements of POPP Smart Thermostat.
Device Reset
If you need to pair POPP Smart Thermostat to a new Zigbee hub/gateway, you must factory reset this device before it
can be paired to a new hub.
To factory reset POPP Smart Thermostat:
1
.
Remove one battery.
2
.
Hold the button on the Smart Thermostat while inserting the battery.
The display will start flashing if performed correctly.
3
.
When the display stops flashing, r
elease the button
.
The POPP Smart Thermostat is now reset to factory default.
4
.
POPP Smart Thermostat will change into the mounting mode. You will see the “M” on the screen of the Smart
Thermostat which indicates that you should now be able to pair your POPP Smart Thermostat to a new Zigbee
hub/gateway.
Note:
If the device is deleted from a hub/gateway, POPP Smart Thermostat should automatically reset. In the case
that it does not, you can use these steps to manually reset POPP
Disassembly of the POPP Smart Thermostat
1.
Press the button on the thermostat until it enters management mode.
2.
Press and hold the button to open the housing and turn the thermostat counterclockwise from the valve.
3.
Remove the adapter from the radiator valve.
