Purple pulsating
Device starts
Flashing purple
Configuration mode
Blue flashing
Establishing a connection to the Wi-Fi network
Blue light
Wi-Fi is connected
Red light
A connection to the Wi-Fi is not possible
Yellow on
No connection to SmartHome Gateway possible
Green flickering
Reception indicator 433Mhz
White flickering
Transmission indicator 433Mhz
Configuration mode:
To start the configuration mode, press the button on the 433 Mhz bridge for 4 seconds. The configuration mode is indicated by a
purple flashing. This mode can only be terminated via the configuration interface.
Resetting the device to the factory settings:
Press the button on the 433 Mhz bridge for 4 seconds, the unit switches to configuration mode, which is indicated by a purple
flash. Press the button again for 4 seconds, the LED changes to yellow before the unit restarts and returns to the factory
settings.
Sources of error:
LED indication
Error
Solution
Glowing yellow
IP address of the SmartHome Gateway is
wrong
Check the IP address of the SmartHome Gateway
within the configuration mode.
Glowing yellow
Does not get an IP address assigned
Check the DHCP settings on your router and in the
configuration mode of the gateway. Specify a static
IP address.
Glowing yellow
Port settings do not match between 433Mhz
Gateway and SmartHome system
Check the transfer port within the configuration
mode of the 433Mhz bridge and in your SmartHome
Gateway. This is 8000 by default.
Blue flashing
(min. 10s)
Wi-Fi connection could not be established
Within configuration mode, check the SSID and
password.
Glowing red
A connection to the Wi-Fi is not possible
Within configuration mode, check the SSID and
password.
Support
If you encounter a problem, please use the international community at www.z-wave.info (English) or www.zwave.de (German),
our website at www.popp.eu/support or contact us by e-mail: [email protected]
Declaration of Conformity
Popp hereby declares that this device complies with the essential requirements and other relevant provisions of Directive RED
2014/53/EU. The complete declaration of conformity can be found at the following address: www.popp.eu/ce
Questions regarding the declaration of conformity should be addressed to the following address:
Popp & Co, Große Johannisstr. 7, 20148 Hamburg, Germany
Disposal guidelines
Electronic devices may not be thrown away in domestic waste, but must be disposed of separately. Please inform yourself about
your local legal regulations and the disposal system available to you. Disposing of electronic equipment in landfills or dumps can
cause hazardous substances to enter groundwater and above into food and ultimately endanger your health.
