7
PE12MAN-REV 01.052419
ADJUSTING THE ALARM SENSITIVITY
NOTE: Alarm is factory-set to the highest sensitivity level.
1) Loosen the screws on the bottom of the sensor tube
as in Figure 13.
2) Slide the adjustment switch from the high
sensitivity position (H) to the low sensitivity
position (L) as in Figure 14.
3) Tighten the screws on the bottom of the sensor
tube to complete the adjustment.
4) Test the alarm to ensure it is performing properly.
ADJUSTMENT SWITCH
DEFLECTOR SHIELD
The deflector shield can be used to lower the sensitivity
of the alarm in cases where the water flow from the
return is setting off the alarm.
1) Snap the shield onto the sensor cage facing the
direction of water flow as in Figure 15.
2) Retest the alarm to ensure it is performing properly.
WINTERIZATION
It is recommended to remove the alarm from the pool when
the water temperature can fall below the freezing point.
1) Remove one of the top seat caps from the pool
section of where the alarm is installed.
2) Remove the screws from the top seat and lift that
end of the top seat.
3) Loosen the mounting bracket screws and slide the
alarm off the top rail of the pool wall.
4) Remove the siren from the upright of the pool.
5) Reinstall the top seat and cap.
6) Store the alarm and its components in a location
that will remain above the freezing point.
Figure 13
Figure 14
Figure 15
Figure 16
SYMPTOM
REASON
SOLUTION
Alarm not sounding
Low battery
Install new batteries
Alarm not activated
Ensure the main switch is turned to the ON position
Sensitivity is set on L or Low
Ensure the sensitivity is set to H or High
Water level too high
Lower water level closer to minimum water level requirement (Fig 16)
Sensor shield blocking wave
Remove sensor shield from sensor cage
Alarm constantly
sounding
Water level low
Raise water level to minimum water level requirement (Fig 16)
Sensitivity set on H or High
Adjust the sensativity to L or Low
Return water flow setting off alarm Adjust the return eyeball to face down and away from the alarm
TROUBLESHOOTING
