Pool Technologie Minisalt Series, Инструкция по эксплуатации

Страница: 11 / 16

5
2.6. Boost mode (optional)
Boost mode sets the production setpoint to its maximum for 24 hours, but can be stopped at any point. This function
can be used when chlorine is urgently needed.
I
To launch Boost mode :
1) The production setpoint must not be at 0.
2) Press the bottom key : the message will remain displayed all through Boost mode.
To stop Boost mode :
Press on the top key.
When Boost mode has finished or is manually stopped, chlorination continues automatically at the initial
production setpoint.
2.7. Cover mode (optional)
Cover mode is used to modulate the production setpoint according to the position of a cover (open or closed), from
an NO electrical switch (normally open) or NC (normally closed).
Operation (default configuration in NO switch) :
- When the switch is activated, production is reduced by 25% in relation to the setpoint. The message is
displayed alternately with the production setpoint.
- When the cover switch is not activated, production follows the set point as shown on the screen.
Activation / deactivation :
1) Press and hold down the bottom key, until the message is displayed.
2) Press on the top key x times until the message is displayed.
3) Press the bottom key : the message or appears.
4) With the top key, move to position to activate Cover mode, or to to disable Cover mode.
5) To confirm, press the bottom key : the display will briefly freeze, then the production setpoint will appear.
Configuration of the switch type (NO or NC) :
1) Carry out steps 1 to 4 below.
2) Press and hold the 2 keys, until the message or appears.
3) With the top key, move to position if the switch type is NO or to if the switch type is NC.
4) To confirm, press the bottom key : the display will briefly freeze, then the production setpoint will appear.