S e r v i c e t r a i n i n g
000
29022000
4.2
Adjustment and service
instructions
Length measuring device
Testing the length measurement
1.
Lift the harvester head so that you can rotate the measuring roller.
2.
Shut the engine off.
3.
Turn on the measurement system, switch on the power to the harvester
head by pulling the knob out on the main switch (moto-switch).
4.
Go to the
length calibration
programming mode.
5.
Write down the original value of the length correction.
6.
Set the length correction of pine to zero.
7.
In the
Handling
mode, select pine for the tree sort.
8.
Press the ENTER key to zero the length.
9.
Mark the zero point on the measuring roller and on the measuring roller
housing. Be careful not to move the roller.
10. Check that the length on the display is zero.
11. Rotate the measuring roller with force e.g., by kicking it.
12. Rotate the measuring roller so the zero mark on the measuring roller is
inline with the zero mark on the measuring roller housing.
13. Check the length on the display. It should be divisible by 50 without a
remainder. E.g., 50, 100, 150, 200, 250, 300, etc.
If the display shows some other length, the measuring system is not
functioning correctly at high speeds.
ATTENTION!
After testing, change the length
correction to the original value.
Repair:
Adjust the gap between the sensor and code roller again. If this does not help,
replace the sensor.
Содержание H73
Страница 1: ...S e r v i c e t r a i n i n g ...
