Under the “CUR” display interface, press “SET” for 2 seconds to enter
backlight setting interface. It will display “LEd” after entering the interface,
and the “ON or OFF” is flickering (as shown in Figure 1). At this time, you can
select to turn “ON or OFF” by pressing “
▼
” or “
▲
” button momentarily, and
after selection, press the “OK” to exit setting. “OFF” means when the device
has no button operation in 10 seconds, the backlight will automatically off
(fault factory setting); “ON” means the backlight will always on.
3. Measure and operation
○
1
E
A
Measuring mode
Under measuring mode one can freely check working Current, Voltage, active
power Watts, Frequency, Electricity Consumption(EC), Cumulative Time(CT)
and Power Factor(PF) by pressing “
▼
”:
WATT
→
CUR
→
VOLT
→
FREQ
→
CT
→
EC
→
PF
. Press “
▲
” the check sequence shall be reversed.
A
○
2
E
A
Electricity Consumption & Cumulative Time
Respectively switch to cumulative Electricity Consumption(EC) monitoring
interface (as shown in Figure 2) and cumulative Consumption Time(CT)
interface (as shown in Figure 3) by pressing “
▼
” or “
▲
”, and the measuring
display ranges shall be 0.00-99,999kWh and 0-99,999 minutes respectively.
The measured electricity consumption value will be automatically stored, and
will not be lost even under long time outage, which is great for circuits that
loose power.
