Pondline Pond Pumps are suitable for filtration systems and
waterfalls in garden ponds and fountains both indoor &
outdoor
Pondline pond pumps are to be used in a submersible application only.
Model
Voltage
Hz
Power
Hmax
Volume
PLDW3500
220-240V
50Hz
25 W
3.0m
3500lph
PLDW4500
220-240V 50Hz
40 W
3.5m
4500lph
PLDW6000
220-240V 50Hz
60 W
4.0m
6000lph
PLDW8000
220-240V 50Hz
80 W
4.5m
8000lph
PLDW10000 220-240V 50Hz
90 W
5.0m
10,000lph
PLDW13000 220-240V 50Hz
110 W
5.5m
13,000lph
PLDW15000 220-240V 50Hz
135 W
6.0m
15,000lph
PLDW18000 220-240V 50Hz
170 W
6.5m
18,000lph
PLDW20000 220-240V 50Hz
200W
7.0m
20,000lph
Safety instructions
Read all of the instructions supplied with this pump
Make sure that your outlet voltage corresponds to that stated on the rating label
of the pump
Make sure the pump is installed correctly before operating
The electrical connection should be located in a water-proof area and should be
at least 2 meters away from the edge of the pond
All electrical connections must be kept dry! Ensure that the electrical cord loops
below the electrical outlet, to form a “Drip Loop”. This will prevent water from
running down the cord into the electrical socket
Always unplug the pump when performing maintenance on the pump or pond
Do not operate if cord or plug are damaged. The supply cord of the appliance
cannot be replaced.
If the cord is damaged the appliance should be
discarded.
For safety reasons, any repair work should be done only by the manufacturer or
authorized service provider
Never hang or move the pump by means of pulling the power cord!
Close supervision is necessary when the pump is used by or near children
If you want to disconnect the pump, you can pull out the plug from the power
supply in an accessible position
Never use accessories which are not recommended by the pump manufacturer.
This may result in fire, electric shock and/or personal injury
The pump is to be supplied through a residual current device (RCD) with a rated
residual operating current not exceeding 30mA
IMPORTANT:
Do not let the pump run dry
– this could cause damage
to the motor.
Submerse the pump completely in the water, a water level of 20cm is required
for submersible use in order to prevent the pump from taking in air
To prevent the pump becoming prematurely clogged, place the pump on a
surface just above that of the sludge on the floor of your pond
The water temperature should not exceed 35
0
C
Do not let the pump freeze over winter
WARRANTY
The warranty is valid for 24 months from the date of purchase.
When
following the directions correctly, the Pondline Pond Pump will perform reliably and
efficiently. Wearable parts are excluded from the warranty. Liability is limited to the
purchase value of the unit only. Any damages as a result of improper treatment
are excluded from the warranty. The warranty is limited to the unit only. In case of
malfunction please contact your retailer.
