PSW2-1000 - HandStand 2
June - 2014
Page 3 of 4
Parts Drawing - Exploded View
Paper Towel Dispenser
The dispenser is designed to accept single or multi fold, as well as roll towels. The
recommended towels are the
Georgia Pacifi c #23504 -
single fold or the
Baywest Ecosoft
#46200
- roll towel.
NOTE: When using other towels, be sure the width does not exceed
9-1/2”.
Emptying Fresh Water
Drain the fresh water by unscrewing the 1” plug located at the bottom of the sink, to the
left of the foot pump. Tighten the plug when fi nished.
Emptying Gray Water
Wheel the sink to a proper and approved drain location. Pull the hose out from the rib
on the back of the holding tank, remove the hose cap and empty the gray water. Re-
place the cap when fi nished.
Filling with Fresh Water
Unscrew the 1” fi ll plug located at the top, left hand side of the wash basin. Insert a
standard 3/4” garden or similar type hose and fi ll with a few gallons of fresh water to
perform a system check. Depress the pump a few times to “prime” it
(the pump has a
built-in check valve that will hold a prime between uses).
If needed, continue fi lling to the
top
(which is the 17 gallon water level capacity).
Tighten the plug when fi nished.
LS04-0001 Soap
Dispenser
(3) PC-000105 - Rivet
(3) PC-000106 - Washer
TD04-1000 - Paper Towel
Dispenser
(4) PC-000105 Rivet
(4) PC-000106 Washer
PC-100451 - 4” Hatch and Cap
(1) PC-100146 - 12” Tether
(4) PC-000102 - Rivet
(3) PC-000106 - Washer
(1) PC-000110 - Rivet
(1) PC-000111 - Washer
PSW1-0001P
- Wash Stand W/Wheels Tank
PC-000377
- 3/4” Garden Hose Cap
PC-000313
- Rubber Hose Washer
PC-000376
- Fitting 1” x 3/4” MGHT
PC-000354
- Hose Clamp
CH100-0435
1”I.D. x 43.5” Long
PC-000354 - Hose Clamp
PC-100316 - Elbow
1” Barb x 1” Barb
PC-000417 - 3/4” Uni-Seal
PC-000417
3/4” Uni-Seal
PSW1-0021 - Axle
PC-000213 - Wheel,
Rubber Tread
PSE2-1000
Euro Wash Stand
Complete
(2) PC-000175 - Screw
(2) PC-000140 - Nut
(4) PC-000123 - Washer
PSW2-1000 - HandStand 2
June - 2014
Page 2 of 4
Parts Drawing - Exploded View
Important Decals
NOT FOR COOKING OR DRINKING
,
required by law in certain areas of the U.S. Other geographi-
cal areas require that the materials used to manufacture the sinks comply with the U.S. Federal
Food and Drug Administration (FDA) guidelines 21 CFR 175.300 (resins), 177.1520 (olefi n polymers)
and 178.3297 (colorants for polymers). The materials also comply with the U.S. Public Health Ser-
vice Drinking Water Standards, 42 CFR part 72 and U.S. Environmental Protection Agency Interim
Primary Drinking Water Regulations 40 CFR part 141.
HANDS FREE SINK
,
instruction for user to use foot pump to operate the sink.
UNIT MUST BE DRAINED BEFORE TRANSPORTING
,
reminds service operator to fully drain both
the fresh water and waste water tanks before transporting.
PC-000581G - Sink Tap
(2) PC-000107 - Rivet
(2) PC-000106 - Washer
PC- 000339
Elbow 3/8" Tube x 3/8" Npt
PC-000554 - 1" Fill Plug
PC-000345 - 1” O-Ring
PC-000325 - Straight
1" Npt x 3/4" Barb
PC-000351 - #10
Hose Clamp
CH075-037 - 3/4"
Drain Hose 37" Long
PSE2-0001
Sink Tank
PC-000415
Rubber UniSeal
CT38-046 - Tubing
3/8" O.D. x 46" Long
CT38-003
3/8" Tubing x 3" Long
PC-000554 - 1" Drain Plug
PC-000345 - 1” O-Ring
PC-000600 - Baby Foot Pump
(4) PC-000102 - Rivet Small Flange
(4) PC-000106 - Washer
PS02-0003 - Foot Pump Plate
(2) PC-000147 - Screw