FS3-3 Assembly July 2016
Page 7 of 16
Insert the edge of the left side panel into the slot on the left side of the door jamb. Line up the holes in the jamb with the corresponding
holes in the side panel. Rivet the second and third holes from the bottom as well as the top two holes using (4) PC-000104 rivets
(as
shown on the left).
Using holes in the jamb as a guide, drill three 13/64” holes into the side
panel. Rivet the PC-000181 cable clip at the center two holes of the jamb using (2) PC-000104
rivets. Rivet the bottom hole using the same rivet. Wrap
the cabana around the base of the unit resting the bottom
edge of the sides on the ledge around the base. Slide the
edge of the right side wall panel into the slot in the jamb.
Line up the holes in the side panel with the corresponding
holes in the jamb and rivet in place using (4) PC-000104
rivets.
DO NOT RIVET THE SECOND HOLE FROM THE TOP
AT THIS TIME
. Using a drill with a 13/64” drill bit, drill out
the third hole from the top as well as the bottom hole. Rivet
the bottom hole using a PC-000104 rivet. The PC-000223
grab handle gets attached to the jamb using (2) PC-000104
rivets at the second and third hole locations.
Step 4: Sidewall Panels to Door Jamb
PC-000104 Rivet
(14) Used in this step
Step 5: Cabana to Base
Insert (2) PC-000175 screws through the holes at the very bottom of the jamb, and (2) PC-
000159 screws through the holes second from the bottom and into the slots in the base. On
the back-side of the unit, center the rear panel on the base. Fasten the rear panel
to the base using (4) PC-000192 sems. Gently lay the unit on it’s back. Place (4)
PC-000123 washers and (4) PC-000140 nuts on the PC-000159 amd PC-000175
screws at the front of the base, but
DO NOT TIGHTEN AT THIS TIME.
Close
the door and tighten the PC-000175 screws
(making sure that there is a 1/4” gap
between the latch side of the door and the jamb).
Open the door and tighten the
pc-000159 screws.
PC-000192 Sems
(4) Used in this step
PC-000140 Lock Nut
(4) Used in this step
PC-000123 - Washer
(4) Used in this step
PC-000159 - Screw
(2) Used in this step
1/4” Gap Between
Door and Jamb
PC-000123 Washers
and PC-000140 Nuts
PC-000175 - Screw
(2) Used in this step
