SAN2-1001/SAN2-1002 Assembly - May 2020
Page 2 of 4
Step 1:
Insert the tabs of one panel into the slots of a second panel and slide down into place. Repeat
this step for the remaining panels.
Assembly Instructions
Wood Block
Step 2:
For the final panel, You will need to twist the whole assembly
to get the last tabs into the slots. To do this, place your foot or a piece
of a 2 x 4 wood block under the panel with the tabs and push down on
the panel with the slots. Place the bottom tab partially into the bottom
slot but do not fully install it. This will hold the two panels into alignment
and enable you to insert the remaining tabs into their corresponding slots.
Once you have all the tabs inserted, you can ‘pop’ the tabs through the
slots and the unit will fully engage.
Step 3:
Slide the leg brace into the slots located at the bottom of the panels and insert the tabs into
the corresponding slots. Pull the tab into the slots. Repeat this for the other leg brace. You will have
to guide the second brace under the first brace and into the slot of the side panel.
Step 5:
Stand the unit upright. If you want to add a ballast of some sort (sandbag, gallon jug(s) of water/sand), do that now by
sliding the ballast down into the center of the Sani Stand.
Step 4:
Turn the unit upside down and line
up the pre-drilled holes in the two leg braces. Fasten into place
using the supplied PC-000369 plastic fastener
