Poly Planar LLC 520 McCormick Dr. Glen Burnie MD. 21061 410-761-4000
www.polyplanar.com
8
Radio Operation
Selecting band & storing presets:
Pressing BAND (7) will toggle through the radio modes as follows FM1 -> FM2 -> FM3
-> AM1 -> AM2. Each band stores up to 6 independent presets for a total of 18 FM and
12 AM presets. To program a preset, tune in the desired station. Push and hold the
desired PRESET button for at least 2 seconds.
Automatically setting the presets:
To automatically set the presets to the next higher stations, press the preset button (1-
6) from which to start programming. Hold the MENU button (10) for at least 2 seconds.
The current preset and additional preset memories up to P6 will be programmed with
the next tunable stations. All 18 FM and 12 AM presets can be set sequentially by
selecting the next band and continuing the operation during auto programming.
Seek & manual tune:
Press the TUNE/SEEK-UP button (5) once to automatically tune to the next higher
station. Press the TUNE/SEEK-DOWN button (6) once to automatically tune to the
next lower station. To manually tune to a frequency, press and hold either TUNE/SEEK
button for at least 2 seconds. Holding the button down will increase or decrease the
frequency manually. When the desired frequency is reached, release the button. The
unit remains in manual tune for 3 seconds after the button is released, so you can still
fine tune with additional button presses. After 3 seconds the seek mode is re-enabled.
Scan function:
Select either AM, FM1 or FM2 mode and press SCAN (8) to listen to a few seconds of
each radio station. SCAN will be displayed in the panel lights. The radio will
automatically SCAN to the next higher station, play that station for a few seconds, then
SCAN to the next higher station. To stop scanning and continue listening to the current
station, press SCAN (8) again. The radio remains in SCAN mode until the SCAN
button is pressed a second time or one of the tune buttons is pressed.
Preset scan function:
Press MENU (10) to enter preset scan mode. The next higher preset station will be
selected and auditioned for 3 seconds while the display flashes. If you wish to remain
on this station, press SCAN (8) a second time. If you do not press the scan button
within 3 seconds, the next higher preset scan station will be selected. The radio
remains in Preset Scan mode until MENU (10) is pressed a second time or one of the
preset buttons is pressed.
Changing the tuner frequency from US to Euro:
Your unit it factory-set to US tuning frequency steps. To switch to Euro tuning steps,
use the switch on the bottom of the unit. With the unit disconnected from the power
source, peel back the sticker on the bottom of the radio and use a screwdriver to slide
