poly-planar GSMR30, Руководство пользователя

Страница: 4 / 18

4
Mounting the Radio (Using the U bracket)
1.Choose a mounting location on the dash board or instrument panel that
will allow room behind to run radio cables to the power source. Consider
how you will use the AUX IN, LINE OUT and USB connectors and route the
appropriate extension cables to an accessible area.
2.Once you have determined a mounting location, you will need to cut a
circular hole 3.1875inches or 81mm in diameter. Cut-out template
available on page
15 . At least 3.75-inch depth is needed to mount the
radio.
IMPORTANT! Do not mount this unit where it can be submerged in
water.
3.Take the U bracket and slide over the two studs on the back of the unit.
Tighten down with supplied nuts.
4.Press on the trim bezel to the front side of the unit.
5.Plug in all wiring harnesses and cables. Refer to the wiring diagram on
page
5 for wire harness connection types.
Tip: When a suitable ground wire is not present in the vehicle wiring
harness. Connect the black ground wire to the vehicle chassis.
Fuse: When replacing the fuse, make sure new fuse is the correct type and
amperage. Using an incorrect fuse could damage the radio.