POLTI VAPORELLA VERTICAL STYLER GSM20, Инструкция по эксплуатации, Страница: 20 / 64

There are 3 levels, adjustable to need and fab-
ric type.
3. USE
3.1 Be sure to follow the directions in Sec-
tion 1.
3.2 Adjust the temperature and amount of
steam based on your needs, as in Chapter 2.
3.3 A triple beep indicates the temperature
has been reached.
3.4 You may now begin steaming the fabric.
The handle has a sensor that produces steam
when it is gripped.
3.5 To remove creases, pass the steam plate
over the fabric. For easier operation, it is best
to stretch the fabric in the opposite direction.
3.6 To revive heavier fabrics, attach the fabric
brush to the steam plate (7). The bristles
open the fibres of more resistant fabrics (like
jackets, coats and textiles), allowing the
steam to work deeper and stretch them.
3.7 For more delicate fabrics, attach the fab-
ric brush without bristles (8) and “skim” the
fabric.
4. AUTOMATIC SHUT-OFF
After about 3 minutes of inactivity, the device
emits a sound and goes into stand-by mode.
(the LED on the display will light up). Reacti-
vate it by gripping the device or pressing the
icon - .
5. OUT OF WATER
If the device stops producing steam, the wa-
ter in the tank has been used up.
Just refill the water tank, as described in Sec-
tion 1, to begin steaming again.
6. GENERAL MAINTENANCE
Before carrying out any maintenance on the
device, always unplug it from the power
mains making sure that the product has
cooled down before proceeding.
To clean the outside of the appliance, only
use a damp cloth.
Do not use detergents of any type.
7. STORAGE
7.1 Disconnect the appliance from the mains.
7.2 Place it on the special base provided.
7.3 Wait for the appliance to cool down
completely before storing it.
7.4 Empty the water tank.
For the best results, the amount of steam is
closely tied to the temperature of the plate.
Steam cannot be produced at the lowest
temperature •.
The steam plate can be rotated horizontally
by pressing the two side buttons (9). To place
the steam plate back into the vertical position,
press the buttons again and rotate (10).
E
N
G
L
IS
H
| 20 |