POLTI VAPORELLA INSTANT VI50.20, Инструкция по эксплуатации

Страница: 14 / 40

14
ENGLISH
11. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Steam does not come out of
the iron.
No power/switched off .
Make sure that the appliance
is connected to the mains
and the switch is on.
Water reservoir empty. Fill the water tank.
The appliance is new, and the
tube that feeds water to the
iron is still empty.
Press and hold the steam
control until it is filled.
Little steam comes out of the
iron.
The steam is dry and not very
visible, but present and effec-
tive.
This is a normal phenomenon
seen in certain environmental
conditions.
You have not pressed and
held the steam button under
the grip on the iron.
Keep the steam button under
the grip on the iron pressed in
while ironing.
You are ironing in Eco mode. For a more powerful jet of
steam, deactivate Eco mode
and activate Max mode.
Water comes out of the iron
instead of steam.
First use. Dispense onto a cloth until
steam comes out of the holes
in the plate (see section 2).
You have just replaced the li-
mescale filter.
Dry the iron with a cloth and
resume normal ironing.
Traces of water remain on the
garments.
The ironing-board lining is
impregnated with water.
Check that the ironing board
is suitable (a board with a grill
that prevents condensation).
On first start-up or after fill-
ing the tank, no steam is dis-
pensed.
The tube that feeds water to
the iron is still empty.
Press and hold the steam
control until it is filled.
Should the problem persist or if it is not in the table, contact an Authorised Polti Service Cen-
tre (see www.polti.com for the up-to-date list) or Customer Care.