POLTI VAPORELLA FOREVER 610, Инструкция по эксплуатации

Страница: 7 / 7

ENGLISH
VAPORELLA FOREVER 610 - FOREVER 615 PRO
30
FILLING THE TANK
Thanks to the self-filling function, there is no
longer any need to stop and wait while the
boiler fills up again.
When the water inside the boiler reaches its
low level, the thermostat will automatically
activate a pump that will fill the boiler from the
tank.
It is necessary to refill the feeder tank with
water before it becomes empty.
If, on pressing the steam request button no
steam comes out and you also hear the
pump noise increase, it means that there is
no more water in the tank.
To keep on working, simply restore the water
level in the self-refilling tank as described in
the “Preparation for use” paragraph.
KALSTOP
Water by its nature contains magnesium, mi-
neral salts and other deposits which in hard
water areas can contribute to limescale build
up in the tank. In very hard water areas we
recommend the use of our KALSTOP FP
2003, a special natural-base decalcifier
which inhibits and breaks down limescale.
This is a preventive against scale build-up
and protects the metal walls of the boiler.
KALSTOP is available from Polti dealers or
from your Polti Service Centre.
CARE OF YOUR VAPORELLA
• Before attempting any maintenance
operation, always disconnect the ap-
pliance from the mains.
• To clean the body of the appliance, simply
use a moist cloth. Do not use solvents or
detergents which may harm the body mate-
rial.
PERIODIC CLEANING OF THE
BOILER
• To maintain optimum performance, clean
the boiler every 10/20 uses depending on
the amount of limestone in the water.
• Disconnect the appliance and let it cool
down for at least 2 hours.
• Empty the water tank to prevent leakage.
• Turn the appliance upside down and using
a suitably sized screwdriver, unscrew the
boiler cap
(12) located on the bottom of the
appliance (Fig. 7).
• Use the funnel ( 13 ) to pour 0,25l of cold
water into the boiler.
CAUTION: do not pour more than the
specified amount of water into the boi-
ler. Pour water slowly, being careful not
to let it overflow, as this could damage
the appliance (fig.8).
• Rinse out the boiler and pour the water
away into the sink or into a container for
collecting dirty water.
• If the water is very dirty, repeat the opera-
tion until it is clean.
• Before screwing the boiler cap (12) back on,
pour 0,1l of water in.
Do not operate the equipment again with
the boiler empty.
• Put the cap back on the boiler, checking
that the seal is present and that the cap is
screwed on properly.
• Fill the water tank again and put the cap
on.
• Turn the appliance on again.
• Before ironing, release steam into the sink
or another container and check that the
steam is clean. This should take a few se-
conds.
• Resume ironing normally.
VL FOREVER 610-615 PRO - M0S10282 1S04_7:FEV 1000-950.qxd 18/05/2012 14.13 Pagina 30