POLTI VAPORELLA FOREVER 1400, Руководство пользователя, Страница: 10 / 10

VAPORELLA FOREVER 1400 - 1402 - FOREVER 1405 PRO
17
ENGLISH
KALSTOP
Water by its nature contains magnesium, mi-
neral salts and other deposits which in hard
water areas can contribute to limescale build
up in the tank. In very hard water areas we re-
commend the use of our Kalstop FP2003, a
special natural-base decalcifier which inhibits
and breaks down limescale. This is a preven-
tive against scale build-up and protects the
metal walls of the boiler. Kalstop FP2003 can
be found in small appliance stores, Polti ser-
vice centres and on the web site
www.polti.com
CARE OF YOUR VAPORELLA
• Before attempting any maintenance
operation, always disconnect the ap-
pliance from the mains.
• To clean the body of the appliance, simply
use a moist cloth. Do not use solvents or
detergents which may harm the body mate-
rial.
CLEANING THE BOILER
ATTENTION - Risk of burns!
Make sure that the boiler is cold and has
been disconnected from the mains for at
least 2 hours.
• To maintain optimum performance, clean
the boiler every 10/20 uses depending on
the amount of limestone in the water.
• Disconnect the appliance and let it cool
down for at least 2 hours.
• Empty the water tank to prevent leakage.
• Turn the appliance upside-down and use
the hexagon wrench ( 13 ) to unscrew the
boiler cap ( 12 ) on the bottom of the ap-
pliance (fig.7).
• Use the funnel ( 14 ) to pour 0,25 litre of cold
water into the boiler.
CAUTION: do not pour more than the
specified amount of water into the boi-
ler. Pour water slowly, being careful not
to let it overflow, as this could damage
the appliance (fig.8).
• Rinse out the boiler and pour the water
away into the sink or into a container for
collecting dirty water.
• If the water is very dirty, repeat the opera-
tion until it is clean.
• Put the cap back on the boiler, checking
that the seal is present and that the cap is
screwed on properly.
• Fill the water tank again and put the tank
lid.
• Turn the appliance on again.
• Before ironing, release steam into the sink
or another container and check that the
steam is clean. This should take a few se-
conds.
• Resume ironing normally.
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Water comes out of the iron in-
stead of steam
The appliance has not reached
the right temperature yet.
The temperature control dial (7)
has set at the minimum
Wait for the “Steam Ready” indicator
light (B) and the iron indicator light
(11) to turn off.
Increase the regulation of the tempe-
rature control dial (7).
The appliance is on but it is not
producing steam Water tank (3) is empty or not in-
serted correctly. Fill the water tank (3).
VL FOREVER 1400-1402-1405 - M0S10930 - 1U02:FEV 1000-950.qxd 25/02/2014 16.45 Pagina 17