EN
G
LIS
H
| 20 |
5. CLEANING CARPETS AND RUGS
5.1 Make sure that chapter 1 has been completed.
5.2 Connect the telescopic tube to the flexible
hose and the floor brush to the telescopic tube.
The length of the telescopic tube can be adju-
sted. Press the button to extend it or shorten
it at will.
5.3 Move the selector located on the brush,
pressing it with a foot, to the no-bristles posi-
tion (4).
5.4 Press the
(5) switch. The appliance will
start to operate.
You can adjust the suction power with the
cursor(6).
5.5 To end suction, press the
(5) switch
again.
6. CLEANING UPHOLSTERY
(mattresses, sofas, car interiors, etc.)
6.1 Make sure that chapter 1 has been completed.
6.2 Connect the mini turbo-brush or the suc-
tion nozzle with bristle frame to the flexible
hose and pass over the surfaces. Using the mi-
ni turbo-brush on armchairs and sofas, car in-
teriors etc., is particularly recommended for
the removal of animal fur and hair, thanks to
the mechanical action of the roller brush. The
suction nozzle with bristle frame is recom-
mended for removing the most stubborn dirt
thanks to the abrasive action of the bristles on
the surface.
If not needed, the bristle frame can be removed
from the suction nozzle (7).
Use the lance for thorough vacuum cleaning
of hard-to-reach spots such as skirting-
boards and folds in sofas, armchairs, uphol-
stered furniture and car upholstery.
6.3 Press the
(5) switch. The appliance will
start to operate.
You can adjust the suction power with the
cursor(6).
6.4 To end suction, press the
(5) switch
again.
7. EMPTYING AND CLEANING THE
DUST CONTAINER
7.1 Switch off the appliance using the
(5)
switch. Disconnect the power supply cable
from the mains.
7.2 Unhook the dust collector from the va-
cuum cleaner by pressing the dust container
release button (9).
7.3 Remove the dust container lifting it by the
handle.
7.4 Press the button located on the container
in order to open the container and remove the
dirt collected (10).
7.5 Remove the handle by turning it anti-
clockwise compared to the container, aligning
the two reference arrows (11).
7.6 Remove the container filter and pull out the
filter unit and remove any remaining dirt.
7.7 Replace the filter unit in the container.
7.8 Reassemble the handle on the container
turning it clockwise, making sure to align the
two arrows (11).
7.9 Reposition the dust container on the ap-
pliance by repeating the steps described pre-
viously in the opposite order.
8. GENERAL MAINTENANCE
Ensure that the appliance is switched off and
disconnected from the mains.
To clean the outside of the appliance, only use
a damp cloth and tap water.
Do not use detergents of any type.
8.1 CLEANING THE DUST CONTAINER
- Pull out the dirt container and remove the
filter unit, as described in the chapter 7.
- Remove the container filter by turning it an-
ti-clockwise relative to the filter unit, aligning
With the manual cursor on the handle of the
flexible hose, it is possible to intervene
promptly in case of accidental suction (i.e.
curtains), reducing the suction power (8).
ATTENTION: since by operating the button
the lower base of the reservoir opens, it is
recommended that this operation be done
over a waste bin.
We recommend to clean the container after
each use.
WARNING: Do not use the appliance without
the dust container complete with filter.
WARNING: Never exceed the “MAX” level
shown on the dust container, otherwise the
filters will clog reducing the suction power of
the appliance.
PRELIMINARE FORZASPIRA C130 - M0S1XXXX - 1Q05_vers7:FEV 1000-950.qxd
08/06/2016
15.22
Pagina 20
