User Guide
P. 9
•
Turn the ignition key to the
IGNITION ON (RUN)
position. (
Do not turn the key
to the
CRANK
position while the engine is running. This would cause the starter motor to re-engage.)
•
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Using the System
Arming and Disarming the System
To disarm the alarm and Starter Kill (if installed) and unlock the doors (if installed):
1.
Press and hold the
UNLOCK
button for approx. 1 sec.
You will hear
two chirps
if the Siren or Horn is so configured.
2.
The icon will light up on the LCD display of the remote control. The parking lights will
flash
twice
and the L.E.D. will go out to confirm that the doors have been unlocked and that the
Starter Kill (if installed) and the alarm are disarmed.
In Passive Mode, the System will rearm automatically 30 seconds after unlocking unless the key is
meanwhile inserted in the ignition switch (see description of
Passive Mode
later in this Guide).
To arm the alarm and Starter Kill (if installed) and lock the doors (if installed):
1.
Press and hold the
LOCK
button for approx. 1 sec.
You will hear
one chirp
if the Siren or Horn is so configured.
2.
The
icon will light up on the LCD display of the remote control. The parking lights will
flash
once
and the L.E.D. will flash slowly to confirm that the doors have been locked and that the
Starter Kill feature (if installed) and the alarm are armed.
Idle Mode
Convenience feature:
Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a conveni-
ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.
To leave the vehicle in Idle Mode:
1.
With the engine running, press the
LOCK
or
UNLOCK
button (to unlock the doors) or the
START/STOP
button on the remote control until the parking lights come on.
2.
Remove the key and exit the vehicle. The engine will go on running.
3.
Lock the doors if needed.
The engine will go on running until the user re-enters the vehicle or until the expiration of the
Engine Run Time .
Caution!!!
Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine.
Proceed as follows to set the system to Turbo Mode:
1.
With the engine already running, press the
LOCK
button on the transmitter until the
parking lights come
ON
.
2.
Remove the ignition key from the ignition switch.
The engine will go on running.
3.
Exit the vehicle and close the door.
