Polarstart PS-5500, Руководство по установке

Страница: 6 / 9

6
IDLE MODE
When programmed this option allows the user to
engage the system to take over the vehicle while it
is already running. This option will keep the
vehicle running for the programmed run time or
until shut down by remote control. To activate Idle
Mode you must do the following:
1. Select Mode 1, Function 2, and Option 2 for
gasoline engines.
2. With vehicle running press either button on the
transmitter until the Parking lights come ON.
3. Remove the key and exit the vehicle.
4. Vehicle will stay running for the entire
programmed run time.
DIESEL ENGINES
All systems are equipped with a dedicated “GLOW
PLUG” input (Pin #4).
This input must be wired to the “Wait to Start”
lights in the vehicle and must receive 12 volts for
as long as the lights are ON. When this input is
used a protection diode must be installed on the
brake input.
Note: Diesel mode must be
programmed for this to work.
RESET TO FACTORY DEFAULT
The reset feature is used to reset the unit to its
original settings, and erase all transmitters from
memory.
It is recommended that a reset be done if the unit is
being re-installed into another car, or if the user has
lost the transmitter and a new one is being
programmed.
NOTE: It is not required that a reset
be done if a new unit is being installed, all systems
are reset to default before they are shipped. After
the unit has been reset the following default options
will be activated.
MODE 1 DEFAULTS
- Ignition lock enabled
- Arming/disarming chirp enabled
- Passive arming
- A single 3/4-second-door lock/unlock pulse
MODE 2 DEFAULTS
- 15 minutes run time
- 3 crank cycles
- 8 seconds crank time
- Gasoline engine
o reset the unit, follow the steps below:
1. Make sure the Alarm Valet Mode and
Starter Valet Mode are disabled . The LED
should be OFF.
2. Open a door.
3. Raise the Hood.
4. Turn the Ignition switch to ON.
5. Press and Hold the brakes.
5. Move the Alarm Valet Switch ON, OFF, ON,
OFF, ON, OFF, ON, OFF, (The switch must
go to ground = ON at least 4 times).
6. Lights flash 8 times to confirm reset.
*If Valet was left ON in step 4, the unit goes in to
a state where you can program new transmitters
for up to 5 seconds by pressing one of the buttons
within 5 seconds. (Parking lights flash 4 times to
confirm a transmitter has been learned.)
PROGRAMMABLE 5
th
RELAY
The 5500 series car starters are equipped with a
high current, programmable 5
th
relay onboard that
can be used to power a second Ignition,
accessory, or crank wire.
The programming is very simple, the unit uses a
series of 3 jumpers, each jumper represents a
function, in order to activate any one of the three
possible 2
nd
outputs, you must place the jumper
(supplied) on one of the three pins and simply
connect the 14awg wire to the vehicles second
Ign/Acc/Crank wire.
NOTE: ONLY ONE OF THE THREE
JUMPERS CAN BE USED AT ONE TIME.