Polarstart PS-3155, Руководство пользователя

Страница: 9 / 12

User guide
P. 9
Note: If the Starter Kill is installed, your vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the
CRANK
position.
Safe Start
If this feature is enabled, the user must press the
START
button 2 times within 3 seconds to remote-
start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing with the
transmitter.
If
Swap Start Mode is selected, to remote-start your vehicle press
LOCK
and
UNLOCK
simultaneously. The
AUX 2
output can be activated by pressing the
START
button.
Installer-programmable Valet Modes
Valet Mode Using the Valet Switch
To put the system i n t o Valet Mode:
1. Turn the ignition key to the
IGNITION ON (RUN)
position.
2. Within 3 sec., press the valet button. The parking lights will flash 3 times.
3. Turn the ignition key to the
IGNITION OFF
position.
The LED on the antenna will come
ON
solid indicating that the vehicle is now in valet mode.
To take the system o u t o f Valet Mode:
1. Turn the ignition key to the
IGNITION ON (RUN)
position.
2. Within 3 sec., press and release the valet button.
The parking lights will flash twice and the LED on the antenna will come
OUT ,
indicating that
the vehicle is now out of valet mode.
Note : Once Valet Mode is activated, the remote starter and alarm functions will be disabled.
“Home Valet TM ” Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.
Note: Once the Home Valet Mode is activated, the vehicle will not start by remote but the
OEM alarm functions will still be enabled.
To take the system i n t o Home Valet Mode:
Press the
LOCK
or
UNLOCK
button.
Within 3 seconds, press the
STOP
button until the Parking Lights go out
To take the system o u t o f Home Valet Mode:
Turn the ignition key to the
IGNITION ON (RUN)
position.
The system will warn you if someone attempts to start your vehicle while it stands in Home Valet
Mode. The parking lights will:
Go
ON
then
OFF
; then
Flash twice , pause; then
Flash twice again.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine.
If your vehicle has an automatic transmission , proceed as follows to set the system to
Turbo Mode:
1. With the engine already running, press the
LOCK
button on the transmitter until the
parking lights come
ON
.