Polaroid Now+, Руководство пользователя

Страница: 13 / 13

12
Safety Information
Caution
• Risk of electric shock
• Do not open/disassemble the
motorized roller system
• Do not disassemble the device.
Incorrect reassembly can cause
electrical shock if the device is
used again.
• Do not immerse the device in water or
other fluids.
• Do not operate the device in a high
humidity environment or very dusty
environments.
• Do not attempt to tamper with, adjust
or remove the battery and/or the
electronics located below the rollers
behind the device’s film door.
• Do not attempt to remove the door
itself as it is connected electronically
to the body of the device. Doing so is
unsafe, will likely damage your device,
and will void your warranty.
• Do not insert metal objects into the
device.
• Do not insert any objects into the
rollers or gears.
• Keep small children and infants away
from device to avoid them being injured
by the device’s moving parts.
• Do not use or store the device near any
heat source or any type of equipment
that generates heat, including stereo
amplifiers.
• Do not use the device near flammable
or explosive gases.
• Do not charge the device if you notice
any unusual odors, noise or smoke.
• Do not attempt to disassemble the
film’s battery or modify it in any way (if
using 600-type film). If battery fluid gets
in your eyes, immediately rinse your
eyes with fresh, cold running water and
seek medical attention immediately.
• Do not cover the flash.
Battery & Charger
• This device uses a custom lithium-ion
battery that is non-removable and
mounted inside the camera body. No
other type of battery can be used.
Battery replacement can only be done
by authorized service centers. The
battery will provide many years of
service if properly used.
• Power consumption varies depending
on the environment the device is used
in and how the device has been stored.
Used immediately after full charge, the
battery will power the processing of up
to 15 film packs.
• Once the battery energy level falls
below a certain level, the device will
no longer process film. The LED will
blink and signal when it needs to be
recharged. This is to avoid a photo
getting stuck as it is being processed
through the roller system.
• The rechargeable battery is not fully
charged at the time of purchase. Charge
the battery fully with the USB charging
cable (provided). This usually takes 1-2
hours (can vary depending on usage).
• The supplied battery charging cable
has been tested to work with the
Apple iPhone power adaptors. While
it can be used in other USB ports e.g.
computer, USB power adaptors, TVs,
cars etc., correct operation cannot be
guaranteed.
• When the device is no longer in use,
please recycle it properly.
Usage Environment
• To protect the high-precision
technology contained in this device,
never leave the camera in the following
environments for extended periods of
time: high temperature (+42°C/108°F),
high humidity, places with extreme
changes in temperature (hot and
cold), direct sunlight, sandy or dusty
environments such as beaches, damp
places, or places with strong vibrations.
• Do not drop the device or subject it
to severe shocks or vibrations.
• Do not push, pull or press on the lens.
Compliance
Important directions for using Lithium–
Ion Batteries:
1. Do not throw into fire.
2. Do not short circuit.
3. Do not disassemble.
4. Do not continue to use when damaged.
5. Dispose correctly after use.
6. Keep away from water.
7. Do not charge when the temperature is
below freezing.
EU Declaration of Conformity
Hereby, Polaroid International B.V.
declares that the Polaroid Now+ analog
instant camera is in compliance with
the essential requirements of the
Electromagnetic Compatibility Directive
(2014/30/EU), Low Voltage Directive
(2014/35/EU) and RoHs Directive
(2011/65/EU) and other relevant
provisions, when used for its intended
purpose.
FCC Compliance Statement
Contains FCC ID: A8TBM70ABCDEFGH
This device complies with Part 15 of
the FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference,
and (2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Caution Caution the user is cautioned that
changes or modifications not expressly
approved by
the party responsible for compliance
could void the user’s authority to operate
the equipment. This equipment must not
be co-located or operated in conjunction
with any other antenna or transmitter.
Note Note his equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
This equipment complies with FCC
radiation exposure limits set forth for an
uncontrolled environment. End user must
follow the specific operating instructions
for satisfying RF exposure compliance.
Industry Canada (IC)
Contains ID: 12246A-BM70BLES1F2
CAN ICES-003(B)/NMB-003(B)
This device complies with part 15
of the FCC Rule and Industry Canada
license–exempt RSS standard(s).
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless
Device is below the Industry Canada
(IC) radio frequency exposure limits. The
Wireless Device should be used in such
a manner such that the potential for
human contact during normal operation
is minimized.
This device has also been evaluated
and shown compliant with the IC RF
Exposure limits under portable exposure
conditions. (antennas are less than 20 cm
of a person's body).
The symbol means that according to
local laws and regulations your
product should be disposed of
separately from household waste. When
this product reaches its end of life, take it
to a collection point designated by local
authorities. Some collection points
accept products for free. The separate
collection and recycling of your product
at the time of disposal will help conserve
natural resources and ensure that it is
recycled in a manner that protects human
health and the environment
Polaroid International B.V.
1013AP Amsterdam
The Netherlands
End of life disposal warning: When the product has come to the end of life, dispose of it in
accordance with local regulations. This product is subject to the EU directive 2012/19/EU on
Waste Electrical and Electronic Equipment (WEEE) and should not be disposed as unsorted
municipal waste.
Made in China for and distributed by Polaroid International B.V., 1013 AP, Amsterdam, The
Netherlands. The POLAROID word and logos (including the Polaroid Classic Border Logo) and
Polaroid Now are protected trademarks of Polaroid.
© 2022 Polaroid. All Rights Reserved.