10
Safety Information
Camera
• Caution: risk of electric shock.
• Do not open or disassemble the
motorized roller system.
• Do not disassemble the device. Incorrect
reassembly can cause electrical shock if
the device is used again.
• Do not immerse the device in water or
other fluids.
• Do not operate the device in a high
humidity environment or very dusty
environments.
• Do not attempt to tamper with, adjust
or remove the battery and/or the
electronics located inside the camera.
• Do not attempt to remove the door
itself, as it is connected to the body
of the device. Doing so is unsafe, will
likely damage your device, and will void
your warranty.
• Do not insert metal objects into the device.
• Do not insert any objects into the
rollers or gears.
• Keep small children and infants away
from the device to avoid them being
injured by the device’s moving parts.
• Do not use or store the device near any
heat source or any type of equipment
that generates heat, including stereo
amplifiers.
• Do not use the device near flammable
or explosive gases.
• Do not charge the device if you notice
any unusual odors, noise or smoke.
• Do not attempt to disassemble the
film’s battery or modify it in any way
(if using 600 type film). If battery fluid
gets in your eyes, immediately rinse
your eyes with fresh, cold running
water, and seek medical attention
immediately.
• Do not cover the flash.
Battery & Charger
• This device uses a custom lithium-ion
battery that is non-removable and
mounted inside the camera body.
• No other type of battery can be used.
Battery replacement can only be done
by authorized service centers. The
battery will provide many years of
service if properly used.
• Power consumption varies depending
on the environment the device is used
in and how the device has been stored.
Used immediately after full charge, the
battery will power the processing of up
to 15 film packs with flash exposures.
Due to the high energy requirements of
the flash, we recommend charging the
camera fully before every session for
best results.
• Once the battery energy level falls
below a certain level, the device will
no longer process film. The battery LED
will blink and signal when it needs to
be recharged. This is to avoid a photo
getting stuck as it is being processed
through the roller system.
• The rechargeable battery is not fully
charged at the time of purchase.
Charge the battery fully with the USB
charging cable provided. This usually
takes 1-2 hours (can vary depending
on usage).
• The supplied battery charging cable
has been tested to work with the
Apple iPhone power adaptors. While
it can be used in other USB ports e.g.
computer, USB power adaptors, TVs,
cars etc., correct operation cannot be
guaranteed.
• When the device is no longer in use,
please recycle it properly.
Usage Environment
• To protect the high-precision
technology contained in this device,
never leave the camera in the following
environments for extended periods of
time: high temperature (+42°C/108°F),
high humidity, places with extreme
changes in temperature (hot and
cold), direct sunlight, sandy or dusty
environments such as beaches, damp
places, or places with strong vibrations.
• Do not drop the device or subject it
to severe shocks or vibrations.
• Do not push, pull or press on the lens.
Compliance
Important directions for using Lithium–
Ion Batteries:
1. Do not throw into fire.
2. Do not short circuit.
3. Do not disassemble.
4. Do not continue to use when damaged.
5. Dispose correctly after use.
6. Keep away from water.
EU Declaration of Conformity
Hereby, Polaroid Film B.V. declares that
the Polaroid Now analog instant camera
is in compliance with the essential
requirements of the Electromagnetic
Compatibility Directive (2014/30/EU),
Low Voltage Directive (2014/35/EU)
and RoHs Directive (2011/65/ EU) and
other relevant provisions, when used
for its intended purpose.
FCC Compliance Statement
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference,
and (2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Caution the user is cautioned that
changes or modifications not expressly
approved by the party responsible
for compliance could void the user’s
authority to operate the equipment.
This equipment must not be co-located
or operated in conjunction with any other
antenna or transmitter.
Note This equipment has been
tested and found to comply with the
limits for a Class B digital device,
pursuant to part 15 of the FCC rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced
radio/ TV technician for help.
This equipment complies with FCC
radiation exposure limits set forth for an
uncontrolled environment. End user must
follow the specific operating instructions
for satisfying RF exposure compliance.
Industry Canada (IC)
This device complies with part 15 of the
FCC Rule and Industry Canada license–
exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Le présent appareil est conforme aux
CNR d’Industrie Canada applicables
aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux
conditions suivantes: (1) l’appareil ne
doit pas produire de brouillage, et (2)
l’utilisateur d’appareil doit accepter tout
brouillage radioélectrique subi, même
si le brouillage est susceptible d’en
compromettre le fonctionnement.
The symbol means that according
to local laws and regulations your
product should be disposed of
separately from household waste. When
this product reaches its end of life, take
it to a collection point designated by local
authorities. Some collection points
accept products for free. The separate
collection and recycling of your product
at the time of disposal will help conserve
natural resources and ensure that it is
recycled in a manner that protects human
health and the environment.
Polaroid Film B.V.
P.O. Box 242
7500 AE Enschede
The Netherlands
End of life disposal warning: When the product has come to the end of life, dispose of it in
accordance with local regulations. This product is subject to the EU directive 202/96/EC
on Waste Electrical and Electronic Equipment (WEEE) and should not be disposed as unsorted
municipal waste.
Made in China for and distributed by Polaroid Film B.V. (P.O. Box 242, 7500 AE), Enschede,
The Netherlands. The POLAROID word and logos (including the Polaroid Classic Border Logo)
and Polaroid Now are protected trademarks of Polaroid.
Fabriqué en Chine pour et distribué par Polaroid Film B.V. (BP 242, 7500 AE), Enschede, Pays-Bas.
Le mot et les logos Polaroid (y compris le Polaroid Classic Border Logo) et Polaroid Now sont des
marques protégées de Polaroid.
© 2020 Polaroid. All Rights Reserved.
Содержание NOW
Страница 3: ......
