B
2. Press and hold
SET
until the red LED blinks twice; then release.
3. Enter
9-9-0
. The LED blinks twice.
4. To view the code for the first digit, press
1
. Count the LED blinks (for example, three blinks = 3), and write down
the number in the appropriate code listing in step 8 under “Programming a Device”.
•
NOTE:
If a code digit is
0
, the LED does not blink.
5. Repeat step 4 for the four remaining digits, using
2
for the second digit,
3
for the third digit,
4
for the fourth digit,
and
5
for the fifth digit.
6. To check for other device codes, repeat steps 1—5, substituting the device key for
TV
.
Changing Volume Lock
The remote comes preset to allow independent volume control of each selected device (Global Volume Unlock). However,
you may change the Volume Lock setting to Global Volume Lock so that one device's volume will control volume in all other
modes. After that, you can perform Individual Volume Unlock on a selected device to set its volume control for independent
operation or Global Volume Unlock to remove all volume locking.
Locking Volume Control to One Mode (Global Volume Lock)
1. Press and hold
SET
until the red LED blinks twice; then release.
2. Enter
9-9-3
and then press the mode key for the device you want to control volume (for example,
TV
). The LED
blinks twice. Now when you press
VOL+
,
VOL-
, or
Mute
, the selected device (for example,
TV
) will control the
volume regardless of the current mode.
Unlocking All Volume Control (Restoring Global Unlock)
1. Press and hold
SET
until the red LED blinks twice; then release.
2. Enter
9-9-3
and then press
VOL+
. The LED blinks four times.
Volume is now independently controlled for all programmed devices.
Unlocking a Single Device’s Volume Control
1. Press a device key (
TV, VCR/DVD, CBL/ SAT,
or
AUX
).
2. Press and hold
SET
until the red LED blinks twice; then release.
3. Enter
9-9-3
and then press
VOL-
. The LED blinks four times.
Volume is now independently controlled for the selected devices.
Troubleshooting
PROBLEM:
LED does not blink when you press a key.
SOLUTION:
Replace battery with one new 3.3 V 2032 Lithium battery.
PROBLEM:
LED blinks when you press a key, but device does not respond.
SOLUTION:
Make sure the remote is aimed at your device and is not more than 15 feet away.
PROBLEM:
LED blinks one long blink.
SOLUTION:
An entry error has occurred (for example, wrong key). Try entry sequence again.
PROBLEM:
Remote does not control devices or commands are not working properly.
SOLUTION:
Try all listed codes for the device. Make sure the device operates with an infrared remote control.
PROBLEM: CH+
,
CH-
, and
LAST
do not work for your RCA TV.
SOLUTION:
Due to RCA design from 1983 to 1987, only the original remote control will operate these functions.
PROBLEM:
No volume on a device.
SOLUTION:
See “Changing Volume Lock”.
PROBLEM:
Channels do not change properly.
SOLUTION:
If the original remote control required you to press
Enter
to change channels, press
Enter
on this remote after
entering the channel number.
Содержание FLM-3732
Страница 1: ...37 LCD Television with NTSC ATSC Tuner FLM 3732...
Страница 59: ......
