Operations in VGA /YPbPr mode
Select VGA/YPbPr mode
PC signal format
Auto adjusting
Connect VGA input and be sure that there is VGA input signal. The
signal format should be set to: 640 x 480@60Hz.
Note:
The resolution of the LCD panel is 640
x
480; any higher resolution
output from your PC Video card might not come in clear.
1
Press the
SOURCE
button on the
unit or button on the remote
control. The screen displays the
menu shown as right.
2
Press
CH
5
/
6
to highlight the
VGA
or
YPbPr/YCbCr
item. Press
VOL+/-
or
wait about 4 seconds and the signal
source is selected.
When VGA signal format is
changed or when you switch to
VGA mode from another source,
the unit adjusts frequency and
phase automatically to obtain the
best display. During the process of
auto correction, the screen
displays
Analog RGB Acquiring
Signal
, and all buttons on the set
and on the remote control do not
work until this process is
finished.
When the set displays some nonstandard VGA signals and can
not adjust the picture to the best status by itself, you can adjust it
again by pressing the
AUTO. ADJ
button on the remote
control.
NOTE:
Please note your final phase and frequency settings as
you might need to re-adjust your screen.
29
Analog RGB
Acquiring Signal
SOURCE
TV
AV 1
AV 2
SVIDEO
YPbPr/YCbCr
VGA
VGA
CLK
