6 I
k
Note 1:
Your TV will switch to the
stand-by
mode in five minutes if there is no broadcast
signal from antenna.
3.
To power on your television,
press the on/off button on the LCD
TV, or any numerical key or
P+
or
P-
keys on the remote control.
Note:
If you are not going to use
your television for a long time,
unplug its power cable from the
socket.
Initial power on and performing
settings
To set up your television, read the sections
on the TV controls and making the channel
settings.
4.3-Batteries
Open the lid of the battery compartment
and make sure that you have placed the
batteries in the correct direction. For this
remote control, UM-4, IEC R03 or AAA 1.5 V
batteries are suitable.
Do not throw your old batteries into the fire,
discard them in a dedicated waste area for
this purpose.
Do not mix used batteries with new ones or
different types of batteries together.
The performance of the remote control will
be reduced at a distance of 8 meters from or
at an angle of 30 degrees beyond the centre
of the TV.
4
Start
Remove your television carefully from its
box. You can keep the packaging of your
television to use in future.
Contents of the box
Power cable (*)
Adaptor (*)
Remote control
2 batteries
Note: The Scart, VGA (*) and RCA
cables are not supplied with the
device.
(*) These features are optional and may not
be available on all models.
4.1-Antenna connection
If you use a 75 Ohm coaxial cable (round
cable) as an antenna cable, connect the
antenna plug directly to the antenna input
located on the TV.
Motorized vehicles, energy lines and
telecommunication lines affect your antenna.
Therefore, be careful to install your antenna
away from these and metal surface in such
a way that it shall not swing. Do not make
your antenna cable longer than required
and do not coil it. Make sure that it is not
crimped passing through a window or door.
Your antenna and cable might be affected
by natural phenomena such as rain, wind,
smoke and humidity over time. Periodically
check your antenna and equipment.
4.2-Powering on your device
and the initial use
1.
Insert the power cable or the adaptor into
the appropriate power supply input located
on the back panel of the LCD TV.
2.
Insert the plug of the power cable or
adaptor, supplied with the device into the
mains socket.
+
P
P
-
