Polaris Timbersled ST 93 RIPPER 2019, Руководство пользователя

Страница: 58 / 84

BRAKE LINE ASSEMBLY AND ROUTING
WARNING
When routing brake lines it is critical that you keep all brake lines away from
any surfaces, such as engine or exhaust, that can become hot while operating
the vehicle. Failure to comply will adversely affect the vehicles brake system
and may lead to severe injury or death.
• Yamaha Models
NOTE
Refer to images of Honda model for routing references.
– For the Yamaha TTR models, run the brake line forward either on top of the
strut rod or located parallel against the left hand side of the strut rod. Secure
the brake line to the strut rod with a cable tie located at the top of the strut rod
and one at the bottom of the strut rod in a similar fashion to the photo for the
Honda model. From here feed the brake line and master cylinder to the right
side of the bike feeding the brake line between the bike’s upper sub-frame
column and the wiring harness brackets on the frame. This will help hold the
brake line against the bikes frame and as far away from the exhaust system
as possible. From here route the brake line forward towards the front of the
bike underneath the bikes fuel tank. Place another cable tie near the front of
the bike securing the brake line to the bikes lower horizontal frame tube.
56
INSTALLATION