Polaris Supersport 2007, Руководство по обслуживанию

Страница: 254 / 266

10.17
Battery and Electrical Systems
10
9923396 - 2007-2012 EDGE/Widetrak LX Service Manual
©2011 Polaris Sales Inc.
ELECTRONIC REVERSE (PERC)
Operation
1. Ensure that the vehicle is stopped and the engine is
warmed up and running at idle.
NOTE: PERC will not engage below 900 RPM or above
4000 RPM.
2. Push and release the yellow reverse button on the left
hand control. The reverse light on the instrument
panel will flash when engine is in reverse motion.
NOTE: The engine will automatically reduce RPM and
it will reverse the rotation of the engine when the RPM
is at the lowest RPM point.
3. Ensure that the path behind the snowmobile is clear.
4. Slowly apply throttle until the sled starts to move in
reverse. Carefully direct the sled in the desired
direction.
NOTE: If the engine stops running or is shut off while
in reverse. The engine will start in forward gear.
FORWARD OPERATION
1. Ensure that the path ahead is clear, then push and
release the reverse button. The engine will
automatically change direction form reverse to
forward and the reverse light on the instrument panel
will stop flashing.
NOTE: When servicing clutches, ensure the driven
clutch is rotated forward. If not, damage to the driven
clutch may occur when removing the belt.
Altitude Setting
At elevations over 6,000 feet (1,829 meters), the engine
requires a different ignition RPM setting to improve the
operation of the reverse system.
To set the altitude settings:
1. With the engine running, push and hold the reverse
button for 5 - 6 seconds and then release the button.
2. The reverse light will flash rapidly on the instrument
panel.
3. To go back to the low elevation setting, repeat step 1.
The reverse light will flash slowly indicating the system
is in the lower elevation setting.
NOTE: The elevation setting will be set in the memory
(engine running or not) until it is changed.
Important Notes
• Max RPM for shifting into reverse = 4000 RPM
• Max RPM for operating in reverse = 6000 RPM
• Engine must first reach 900 RPM at start up before
the reverse system can be used.
• Flashing light on the instrument panel indicates
that the system is in reverse. On carbureted units
a slow flash indicates that the system is set for low
elevation, and a fast flash indicates the system is
set up for high elevation. Push and hold the
reverse button for longer than 5 seconds to toggle
back and forth from high and low elevation
settings.
• If engine is shut off or dies in forward or reverse
gear, the engine when started will automatically be
in forward gear.
• When servicing clutches, ensure that the vehicle is
in the forward gear.
WARNING
Reverse operation, even at low speeds, may cause
loss of control, resulting in serious injury or death. To
avoid loss of control, always:
LOOK BEHIND BEFORE AND WHILE BACKING.
AVOID SHARP TURNS.
SHIFT TO OR FROM REVERSE ONLY WHEN
STOPPED.
APPLY THROTLE SLOWLY.
CAUTION
To avoid personal injury and/or engine damage, do not
operate the electric start or recoil while engine is
running.