DRIVE CHAIN LUBRICATION AND ADJUSTMENT
Lubricate the drive chain with Polaris chain spray lube or an approved chain lube
at the interval specified in the Periodic Maintenance Chart. Lubricate more often
under severe use, such as in dirty or wet conditions.
IMPORTANT
Washing the drive chain with a high pressure washer or solvents can cause
premature wear and chain failure. Do not use a high pressure washer or
gasoline to clean the drive chain. Operating the vehicle with improper rear
drive chain deflection can result in severe damage to the transmission and
drive components. Always make sure the chain adjusted within the stated
specifications.
1. Loosen upper nut
q
on the chain tensioner bracket.
2. Turn lower nut
w
clockwise in 1/2 turn increments, then turn upper nut until
tight. Follow this procedure until chain is at proper tension. To check for
proper tension, press the down on the middle of the chain with thumb using
100N (22 lbs) of force. Chain deflection
e
should be within specification.
MEASUREMENT
Chain Deflection:
Using 100N (22 lbs) of force
New Chain:
5 - 10 mm (3/16 - 13/32”)
Broken In Chain:
10 - 15 mm (13/32 - 19/32”)
NOTE
A new chain will stretch after the vehicle is used for a period of time.
3. Repeat these steps until chain is adjusted to desired deflection.
70
Downloaded from
Содержание ACE 150 EFI 2019
