Page 10
3
Figure 22. Keep Cleaner Vertical to Drain Water
Removing the 9300xi Sport
CAUTION
To prevent damage to the 9300xi Sport, be sure to
adhere to the following guidelines:
1.
After the cleaning cycle is completed, the four (4)
lights located on the control unit will
fl
ash slowly
to indicate that the cleaner may be removed from
the pool.
2.
Disconnect the control unit cable from the
electrical outlet.
3.
Disconnect the cable from the control unit.
4.
Never lift the 9300xi Sport out of the pool by the
fl
oating cable. Always use the handle to remove it
from the pool. Refer to Figures 21 and 22.
5.
Coil the cable starting at the cleaner and go
toward the connection point at control unit.
Remove coils or twists along the way.
6.
Store the Polaris 9300xi Sport on the caddy with
the cable coiled when not in use.
IMPORTANT NOTES
•
The 9300xi Sport includes a safety feature that
automatically stops the cleaner after 20 seconds, if
it is powered on, but not submerged in the water.
For pools equipped with a beach area, this safety
feature allows the cleaner to reverse, and back into
the pool when the impeller is out of the water.
•
Use your 9300xi Sport cleaner as often as needed
to keep your pool clean.
• Clean
the
fi
lter canister after each cleaning cycle.
•
Do not leave your cleaner in the pool on a
permanent basis.
•
At the end of each cycle, remove the cleaner from
the pool. Start at the cleaner head and untangle any
coils in the hose before storing the cleaner.
•
Remove the 9300xi Sport from pool when super
chlorinating.
IMPORTANT
•
Use your cleaner as often as needed to keep your
pool clean.
• Clean
the
fi
lter canister after each cleaning cycle.
•
Do not leave your cleaner in the pool on a
permanent basis.
•
At the end of each cycle, remove the cleaner from
the pool. Start at the cleaner head and untangle any
coils in the hose before storing the cleaner.
9300xi Sport
1.
Plug the control unit into a GFCI protected power
source.
Select either the Cycle I or Cycle II cleaning
program on the control unit:
Cycle I Program
Cycle II Program
• Completed in 1.5 hours
• Completed in 2.5 hours
• Maximum coverage in
minimal time
• Intensive and complete
cleaning
• Thorough tile cleaning
2.
To start your 9300xi Sport cleaner, press the button
for "Cycle I" cleaning program. "Cycle I" cleaning
is the primary cleaning cycle for inground pools.
3.
When the "Cycle I" program button is selected the
indicator light above will illuminate. The cleaner
will start in a few seconds.
4.
Depending on the state of your pool it is possible
to modify the time of the cleaning cycle by
pressing
the button. Pressing the
button
will increase the cleaning time by 60 minutes or
decrease the cleaning time by 30 minutes. When
the cleaner is powered on, the Cycle and time will
correspond to the cycle and the time that were
active at the time it was last switched off.
5.
If you wish to stop the cleaner during a cleaning
cycle, press the "Power" button. Refer to Figure 20.
English
Содержание 9300 Sport
Страница 18: ...Page 18 NOTES English ...
Страница 35: ...Page 35 Français NOTES ...
