26
FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
Information Display Mode
This area will display clock, odometer, trip meter, state of charge
(SOC), range meter, efficiency rate (EFF) or any existing fault
codes or warning messages.
The display can be changed to show either standard or metric
units of measurement for each of the following settings.
Tip:
To exit the set-up mode, turn the key off. Wait 5 seconds, then turn the key on. The gauge displays
the mode that was displayed prior to setting the units.
1. Turn the key to the OFF position.
2. Press and
hold
the MODE button while turning the key to the ON position.
3. When the display flashes the distance setting, tap the MODE button to advance to the
desired setting.
4. Press and
hold
the MODE button to save the setting and advance to the next display
option.
5. Repeat the procedure to change remaining display settings.
Clock Resetting
Tip:
The clock must be reset any time the batteries have been
disconnected or fully discharged.
1. Turn the key to the ON position. Use the MODE
button to toggle to the clock display.
2. Press and
hold
the MODE button until the hour
segment flashes. Release the button.
3. With the segment flashing, tap the MODE button to
advance to the desired setting.
4. Press and
hold
the MODE button until the next segment flashes. Release the button.
5. Repeat steps 3-4 twice to set the 10-minute and 1-minute segments. After completing the
1-minute segment, step 4 will save the new settings and exit the clock mode.
6. Turn the key to the OFF position.
Standard Display
Metric Display
Distance
Miles
Kilometers
Temperature
Fahrenheit
Celsius
Time
12-Hour Clock
24-Hour Clock
MODE
Button
