Polaris 2004-2005 Sportsman 6x6, Руководство по обслуживанию

Страница: 68 / 289

GENERAL INFORMATION
3.10
CRANKSHAFT
STRAIGHTENING
Lubricate the bearings and clamp the crankshaft
securely in the Crankshaft Truing Stand ( PN
2870569 ). Refer to the illustrations below.
Crankshaft Truing Stand
(PN 2870569)
NOTE: The rod pin position in relation to the dial
indicator position tells you what action is required to
straighten the shaft.
A
B
HIGH .004 (.1mm)
HIGH .004 (.1mm)
SUPPORT CRANKSHAFT
HERE.
1. To correct a situation like the one shown in the
illustration at right, strike the shaft at point A with a
brass hammer.
A A
HIGH .002 (.05mm)
HIGH .005 (.13mm)
2. To correct a situation like the one shown in the
illustration at right, squeeze the crankshaft at
point A. (Use tool from alignment kit).
A
HIGH .002 (.05mm)
HIGH .005 (.13mm)
A
3. If the crank rod pin location is 180
_
from the dial
indicator (opposite that shown above), it will be
necessary to spread the crankshaft at position A
as shown in the illustration at right. When
rebuilding and straightening a crankshaft, runout
must be as close to zero as possible.
NOTE: Maximum allowable runout is .0024
I
.
ENGINE LUBRICATION -
EH50PL
Oil Type Polaris Premium 4 Synthetic . . . . . . . . . . . . .
( PN 2871281 )
Capacity Approximately 2 U.S. . . . . . . . . . . . .
Quarts (1.9 l)
Filter
(PN 3084963) . . . . . . . . . . . . . . . .
Filter Wrench (PV--43527) . . . . . . . .
*Drain Plug / Screen Fitting 14 ft. lbs. (19 Nm) (If . .
fitting is removed, follow oil pump priming procedure).
*Oil Pressure Specification
20 PSI @ 5500 . . .
RPM, Polaris 0W--40 Synthetic (Engine Hot)