Polaris 2001 50 SCRAMBLER, Руководство пользователя

Страница: 111 / 125

ELECTRICAL
5.9
IGNITION SYSTEM
Whenever troubleshooting an electrical problem you should first check all terminal connections to be sure they
are clean and tight. Also be sure that colors match when wires are connected. Use the following pages as a guide
for troubleshooting. The resistance values are also given on the specification pages.
Condition: No Spark or intermittent spark
Disconnect the black wire at the CDI module
to isolate the ignition from the kill system.
Does it have spark?
-Test the ignition switch and engine
stop switch circuit for shorts to
ground.
-Check connectors for moisture,
wire color matching or corrosion.
Yes
No
Yes
Check coil ground connection between engine and coil
mount using an ohmmeter. The coil mount should
have good continuity to ground on the engine (0-.2
Ω)
.
Replace Spark Plug
Disconnect and check the secondary coil. Resis-
tance values should be:
Primary Side - Primary Wire Tab to Ground
(on coil mount or engine): .2 to .3 Ohms
Secondary Side High Tension Wire to engine
ground- Cap installed - 8000-9300
Ω
Cap removed - 3000-4200
Ω
Are these values within specs?
Replace the ignition coil.
No
Yes
If all of the above tests are within specifications, and all grounds, connections, and wire color coding
have been inspected, perform voltage output tests on following page or replace the CDI module.
Clean coil mounting area.
Repair ground wire connections.
No