Polar Fire PFPM-5210, Инструкции по сборке и схемы запчастей

Страница: 8 / 16

HOT ENGINE START:
1. Continue with Step 6 of Cold Engine Starting.
If engine does not fir e, refer to Step 1 of Warm Engine Starting.
DO NOT ATTEMPT TO START ENGINE IN THE FOLLOWING WAYS:
• DO NOT use star ting fluid.
• DO NOT spra y flamma b le liquids or v apo r s into air cleaner,
carb uretor or spark plug c hambe r .
• DO NOT remove spark plug and pull on sta rter r op e . Flam -
ma ble fuel can spra y out & ignite f r om a spark f r om spark
plug .
MAINTENANCE AND STORAGE
AUGER MAINTENANCE
1. The gear case has 4 oz. of grease installed at the factory. It is
recommended that once a year the gear case be split and the
grease level checked. Add grease only if level of grease is below
top of the gears. DO NOT OVERFI LL.
2. Keep all screws, nuts, and bolts tight.
3. For cold weather operation, store the unit in a cool environment.
Transferring the unit from a warm to a cold place can cause the
build up of harmful condensation.
4. Always replace blade protector when power auger is not in use.
5. If blade performance decreases, turn unit off and disconnect
spark plug wire. Carefully inspect cutting edge of blades for any
knicks or shiny areas. If blades show any of these signs, they
need to be resharpened or replaced.
ENGINE MAINTENANCE
COOLING FINS
Cooling fin s, air inlets and linkages must be free from any debris
before each use.
AIR FILTER
Never run engine without air cleaner properly installed. Added wear
and engine failure may occur if air cleaner is not installed on engine.
Service air cleaner every 3 months or after 20 hours of operation.
Clean filter daily in extremely dusty conditions.
STEPS FOR CLEANING AIR FILTER
1. Wash in warm water with mild soap until dirt and debris are
removed. Press filter when washing, do not twist.
2. Rinse in warm water until soap and dirt are removed.
3. Dr
y filter by wr apping in a clean cloth and pressing filter until it is
dry.
4. Apply oil to the entire filte r.
5. Remove excess oil.
6.
Attach the filter and air cleaner c over to the engine.
CAUTION
!
TO PREVENT ACCIDENTAL STARTING:
AVOID INJURY! ENGINE MUST BE TURNED OFF
AND COOL, AND SPARK PLUG WIRE MUST BE RE-
MOVED FROM SPARK PLUG BEFORE CHECKING
AND ADJUSTING ENGINE OR EQUIPMENT .
AVOID INJURY! TEMPERATURE OF MUFFLER
AND NEARBY AREAS MAY EXCEED 150º F (65º C) .
AVOID THESE AREAS .
AVOID INJURY! CHECK AUGER OFTEN FOR
LOOSE NUTS AND BOLTS . KEEP THESE ITEMS
TIGHTENED .
AVOID INJURY! NEVER STORE ENGINE WITH
FUEL IN THE TANK INSIDE A BUILDING . POTEN-
TIAL SPARKS MAY BE PRESENT FOR IGNITION
OF FUEL AND FUEL VAPORS .
AVOID INJURY! AN ADULT MUST ALWAYS DO
MAINTENANCE AND REPAIR ON ENGINE AND AU-
GER .
AVOID INJURY! ENGINE MUST BE SHUT-OFF,
COOL, AND SPARK PLUG WIRE REMOVED BE-
FORE ANY REPAIR OR MAINTENANCE CAN BE
DONE .
2.
8