Polar Electro Look Keo Power, Руководство пользователя

Страница: 12 / 22

6. INSTALL TRANSMITTERS
After installing the pedals, install the transmitters
to the bike. The transmitters are marked R (right),
and L (left). With correct pedal installation, the
transmitters point forward when the cranks face
up. See picture for correct transmitter positioning.
Perform the steps below to both transmitters:
1.
Remove the protective cap from the
transmitter.
2. Insert the transmitter into the pedal axle. Check
that the shape of the transmitter corresponds
with the shape inside the pedal axle. Push
firmly but do not use too much strength. Using
too much strength can damage the transmitter.
3. Check that the transmitter is positioned
correctly (see picture). If the transmitter is in
an incorrect position, remove it and adjust the
pedals so that the transmitter attaches
correctly.
4. Pass the cable tie through the hole in the
transmitter. Press and hold the transmitter in
place, and tighten the cable tie around the
crank. Cut off any excess ends.
5. Before cycling, rotate the cranks with the chain
on the outer chainring and smallest sprocket,
and check that the transmitters do not hit any
part of the bike or the chain. The system is not
compatible with all bike setups.
E N G L I S H
12 Install Transmitters